1. DL manuals
  2. Xomax
  3. Car Seat
  4. XM-KI6
  5. Instructions Manual

Xomax XM-KI6 Instructions Manual

Manual is about: ISOFIX, with top tether

Summary of XM-KI6

  • Page 1

    Instructions isofix car seat (with top tether) group 1,2,3 instructions: please read carefully and keep for future reference. Your child’s safety may be affected if you do not follow these instructions. This product conforms to ece r44.04 group 1,2,3 child car seat. Suitable for children from 9kg to...

  • Page 2: 1.1 Notices

    1.1 notices 1. This child car seat is approved for two different types of fitting: a) “universal isofix” for use as a group 1 [9-18kg] car seat locked onto the vehicle’s isofix anchor points in conjunction with the car seat’s integral 5-point harness. B) “universal” for use with just the vehicle’s 3...

  • Page 3: 1.2 Getting Started

    1.2 getting started read carefully before attempting to fit the child car seat warning: never leave your child unattended – your child’s safety is your responsibility. Warning: the child car seat must be fitted in accordance with the manufacturer’s instructions. Incorrect installation could be dange...

  • Page 4

    From inside. Warning: allow the child a break during long car journeys and make sure they don’t get out of the car unaided and without supervision. Warning: the child car seat must be fitted securely to the passenger seat. Ensure that it is not loose or wobbly after you have fitted it. If it is loos...

  • Page 5

    Warning: avoid winter clothing bundling - bulky clothing can lead to incorrect harness tightening. In an accident, the child can slip right out of the extra padding - and thus out of the seat. Let the car warm up or cool down prior to placing your child in there if possible. If your child is cold, p...

  • Page 6: 1.3 Part Checklist

    Original owner uses it. Warning: you must replace the child car seat and your vehicles seatbelts if they becomes badly worn or damaged. Warning: you must replace the child car seat if it is involved in an accident – it may have unseen damage and may not protect your child as well as they should. At ...

  • Page 7

    1.4 positioning the car seat the child car seat must only ever be used on a forward facing passenger seat without an active airbag. Whilst in group 1 mode, the child car seat can only be installed using the isofix anchor points with the top tether. It must not be installed with out the top tether wh...

  • Page 8

    Similar to (b). If unsure or in any doubt then consult your vehicle manufacturer. 2. Locate your vehicle ’ ’ ’ ’s top tether anchor points. These may be either located high up near a parcel shelf (type 1), or low down on the vehicle floor (type 2) or on the back of the passenger seat(type 3). Warnin...

  • Page 9

    1.5 adjusting the head/harness height 1.Remove the harness strap loops from the yoke. 2.Pull the harness straps through the backrest. 3.Reinsert the harness straps through proper slots.Make sure both straps are at the same level and are not twisted. 4.Reassemble the harness strap loops on the yoke,s...

  • Page 10

    1.6 five point positioning 1.7 remove the 5 point harness from the back of the carseat can release the velcro of the shoulder. From the bottom of the carseat can take over the metal plate, then remove all 5 point harness. Remove the metal plate, need cut of the front of the webbing which has already...

  • Page 11: 1.8 Adjusting The Buckle

    1.8 adjusting the buckle 1.Join the 2 buckle metal connectors. 2.Pass both connectors through the slot in the upper part of the until you hear a “click”. 3.Always make sure the harness is properly fastened by pulling the harness straps upwards. 4.To unfasten the harness press the red button on the b...

  • Page 12: 1.10 Loosing The Harness

    1.10 loosing the harness 1.The harness is loosened by pressing the adjustment button of the harness (under the seat cover) at the front of the seat 2. Press the lever that is marked with “press” down with one hand while holding both harness straps with your other hand. 3. Pull the harness straps tow...

  • Page 13: 1.11 Adjusting The Isofix

    1.11 adjusting the isofix pulling the red handle attached to the base meanwhile pull out both isofix arms as far as they will go.If you want to remove isofix fitted, pulling the red handle attached to the base meanwhile pull in both isofix arms as far as they will go. 1.12 installing the car seat an...

  • Page 14

    Red isofix/easyfix system strap(refer to 1.11). 3. Position the car seat on the rear seat of the vehicle bring the isofix/easyfix connectors in line with the seat’s isofix anchor points . 4. Click the isofix/easyfix connectors into the anchor points; the indicators on each connector should turn from...

  • Page 16

    10. If you want to remove isofix fitted, pulling the red handle attached to the base meanwhile pull in both isofix arms as far as they will go. Group 2&3 (15-36kg) with 3-point safety belts, universal u se ensure the child car seat is correctly installed using either the isofix system or if no isofi...

  • Page 17

    Group 2&3 (15-36kg) with 3-point safety belts + additional attachments (fit), semi-universal use if you are just using the 3-point seatbelt +additional attachments (fit) install the car seat, then you must not use the top tether. Please refer to 1.7 remove the 5 point harness 1.Put the child seat on...

  • Page 19: Removing The Cover

    Removing the cover remove the headrest cover. Remove the backrest cover. Remove the cushion cover`. Care & maintenance 1) store this child car seat in a safe place when not in use. 2)do not place heavy objects on top of it. 3) always store the child car seat in a dry environment. 4) do not store the...

  • Page 20

    11)you must not oil or lubricate any part of the seat shell. 12) the child car seat may have a slight rattle when not in use, this is normal. If in any doubt, contact distributor immediately. 13) check the adjustable parts of your child seat at intervals of about 6 months to ensure it is still fits ...