Xomax XM-RSU254BT User Manual - Installation
INSTALLATION
Installation Procedures
First complete the electrical connections and then check for correctness.
This unit can be installed in any dashboard Having
an opening as shown the right figure.
Installation Opening
To Install the Car Radio
Be sure you test all connections first, and then follow these steps to install this unit.
1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery’s
negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Press the button on the front panel to flip down the front panel and remove it.
4. Lift the left or right top corner of the plastic outer trim ring then pull it out to remove it.
5. Insert the two bracket keys into the left and right side of the chassis, as shown the below
to separate the chassis from the housing.
6.
7. Insert car radio into the mounting sleeve.
figure
Insert mounting sleeve into the dashboard and bend the mounting tabs out with a screw-
driver. Make sure that the lock lever is flush with the mounting sleeve and is not projecting
beyond.
2
182 mm
53 mm
Bracket key
Bracket key
Plastic outer trim ring