Xpand X105-IR-X1 User Manual - Turning On/off Your Glasses

© XPAND, All Rights Reserved. 

2 

www.xpand.me

Turning On/Off Your Glasses 

» Step 1 ON: Press button (1) once

» Step 2 LED light (2) will light up from off to bright

» Step 3 OFF: Press button (1) once

» Step 4 LED light (2) will light up brightly and then dim from bright to off

The glasses turn off automatically if no 3D signal from a TV or emitter is detected 

for 5 minutes.

Set Your Glasses to Operate with Your 3D Device

The XPAND 3D Glasses Lite (IR) recognize your 3D device automatically.

Please note that it may take from few seconds to one minute for glasses to 

synchronize with your 3D device at a very first time. After that the glasses start to 

operate within a few seconds after being exposed to the same 3D IR signal. 

Set Your Glasses to Operate in Dual View Mode

When the 3D device (TV, projector, etc.) is emitting a dual view image, the glasses 

automatically switch to Dual View operation mode. To change the Dual View mode 

between Player 1 and Player 2 view, double click on the button (1). 

When double click is detected, LED light (2) indicates the eyewear mode:

Player 1: One Quick Blink

Player 2: Two Quick Blinks

Dual View not available: One Long Blink 

Please note that Dual View functionality is available only with Panasonic and Philips 

IR 3D TVs from 2011 or later.

Battery Low Indication

If LED light (2) is flashing with short blinks, the battery level is low. The glasses will 

continue to operate normally until the battery is completely discharged. 

Charging the Battery

To 

charge the eyewear, use the micro USB cable to connect the USB charging port 

on the glasses to a powered USB port (computer or wall charger with USB compliant 

output). LED (2) will stay brightly lit until charging is completed. Charging usually 

takes up to two hours. 

Please, fully charge the glasses prior to the first use. 

Please note that the glasses can’t be used during charging.