Xpelair 100MM/4" RANGE DX100 Installation And Maintenance Instructions Manual

Manual is about: Toilet/Bathroom 100mm/4" Fan Range

Summary of 100MM/4" RANGE DX100

  • Page 1

    Installation and maintenance instructions dx100 standard dx100 pc pull cord dx100t time r dx100h humidistat dx100hp humidistat and pull cord dx100pir integral body movement sensor dx100vtd delay timer toilet/bathroom 100mm/4" fan range retain for future reference ® gb f d nl i s gr n se a.

  • Page 2

    2 a b d e f g c dx100pir 125mm 115mm.

  • Page 3

    H 3 i j k dx100t dx100pir dx100h & dx100hp l.

  • Page 4

    Gb xpelair toilet/bathroom fans dx100, dx100pc, dx100t, dx100h, dx100hp dx100pir & dx100vtd installation & operating instructions please leave this leaflet with the fan for the benefit of the user installing the fan these appliances are intended for connection to fixed wiring. Check that the electri...

  • Page 5

    Airflow across the room (e.G. Opposite the internal doorway). • near the source of steam or odours. • not where ambient temperatures are likely to exceed 50˚c. • if installed in a kitchen fans must not be mounted immediately above a cooker hob, or eye level grill. • if installing in a room containin...

  • Page 6

    Gb xpelair toilet/bathroom fans dx100, dx100pc, dx100t, dx100h, dx100hp dx100pir & dx100vtd installation & operating instructions please leave this leaflet with the fan for the benefit of the user 6 3. If the shaft has cavity wall, use the wall tube to bridge the cavity. 4. Fit ducting and condensat...

  • Page 7

    7 fuse for the appliance must not exceed 5a. Dx100t only i • to adjust the over-run period turn the control (t) clockwise to increase and anti-clockwise to decrease. Dx100h & dx100hp only j • humidity operation is factory set at approx. 70% relative humidity (rh), but can be adjusted between 50% and...

  • Page 8: Notes

    Notes dx100, dx100pc, dx100t, dx100h, dx100hp, dx100pir & dx100vtd 54.

  • Page 9

    55.

  • Page 10

    Do's and dont's • do read all the instruction leaflet before commencing installation. • do install each fan with a double pole isolating switch with a contact gap of 3mm in each pole. • do make sure the mains supply is switched off before attempting to make electrical connections or carry out any ma...