Xplore M6 User Manual - page 13
NOTICE:
The SAR limit of Europe is 2.0 W/kg. Device types M6 has also been tested against this SAR
limit. The highest SAR value reported under this standard during product certification for use at
the ear is 0.19W/kg and when properly worn on the body is 1.4W/kg This device was tested for
typical body - worn operations with the back of the handset kept 0.5cm from the body. To main-
tain compliance with RF exposure requirements, use accessories that maintain a 0.5 cm separa-
tion distance between the user's body and the back of the handset. The use of belt clips, holsters
and similar accessories should not contain metallic components in its assembly. The use of
accessories that do not satisfy these requirements may not comply with RF exposure require-
ments, and should be avoided.
Working Temperature: -20℃ ~ +45℃
Storage Temperature: -40℃ ~ +70℃
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
Hereby, [ Xplore Technologies Corp ] declares that the radio equipment type [M6] is in compli-
ance with Directive 2014 / 53 /EU.
The full text of the EU declaration of conformity is available at the following internet address:
https://support.xploretech.com/us/support/userdocs/
This device complies with Part 22 & 24 and Part 27 of the FCC Rules.
SAR INFORMATION
The SAR limit of FCC and ISED is 1.6 W/kg averaged over one gram of tissue. Device types
M6 ( FCC ID:Q2GiX006M1 and IC:4596A-iX006M1) has also been tested against this SAR limit.
The highest SAR value reported under this standard during product certification for use at the ear
is 0.702 W/kg and when properly worn on the body is 1.305 W/kg. This device was tested for
typical body -worn operations with the back of the handset kept 1 cm from the body. To maintain
compliance with FCC and ISED RF exposure requirements, use accessories that maintain a 1
cm separation distance between the user's body and the back of the handset. The use of belt
clips, holsters and similar accessories should not contain metallic components in its assembly.
The use of accessories that do not satisfy these requirements may not comply with FCC and
ISED RF exposure requirements, and should be avoided.
Charging mode need to operate indoors, please pay
attention to the environment temperature should be
-20℃ ~ +35℃