XPROHELI DYS 3X User Manual - page 23
User Manual
XProHeli DYS 3XBrushless Gimbal
DYS 3X Brushless Gimbal For GoPro
Page 20
©2014 XPROHELI. All Rights Reserved.
Follow PITCH, ROLL: This mode is activated on Profile 2. This
mode will allow both the PITCH and ROLL axis to follow the
frame of the gimbal with the following parameters:
Follow ROLL start degrees: Set the PITCH angle (in
degrees) where the ROLL axis enters Follow mode.
Below this angle, ROLL remains locked to the horizon.
The purpose of this setting is so the ROLL does not
remain locked at high degree pitch angles.
Follow ROLL mix degrees: Set the PITCH range (in
degrees) where the ROLL axis gradually transitions from
‘lock’ mode to ‘follow’ mode. To disable ROLL follow
completely set the Roll start/mix values to (0,90). To
permanently enable the ROLL follow mode set
start/mix values to (0,0)
Note: The DYS 3X is preconfigured in Profile 2 to only
activate the follow PITCH feature.
Tuning Follow mode features (Profile 1/2)
There are a few primary variables that can be adjusted to
change the reaction speed and settings of the YAW (pan)
axis.
Dead band, degrees: Increasing this value will adjust
the starting point (+/- degrees from center) that the
camera begins to follow your hands left to write. A
smaller value here will ‘tighten’ the reaction zone from
the zero point and begin to follow to the left or right
sooner.
A larger value here will give your hands more freedom
of movement to the left and right before the camera
begins to follow. You can set this range where your
preference suites your needs. The rotation of an outer
frame or handles does not
affect the camera within this degree band. This setting
helps to skip small pan jerks when you operate gimbal
by hands during fast or dynamic movements.