XPROHELI Silk Quick Start Manual - page 6
User Manual
XProHeli Silk Quickstart Guidel
XProHeli Silk Quickstart Guide
Page 4
©2014 XPROHELI. All Rights Reserved.
9. To adjust the pan axis you will need to slightly loosen the 2 clamps
at the bottom of the pan axis motor. The pan axis adjustment is
made by sliding the top carbon fiber tube inward/outward and by
rotating it to the left or right.
10. Adjust the pan axis similar to the roll and pitch axis by holding up
the top pan axis plate at a 90 degree angle. If the gimbal assembly
is weighted to far forward or too far back it will fall to the weighted
side. Adjust this by sliding the tube inward or outward. A perfectly
balance pan axis will hold position by its self in all 360 degrees of
motion.
11. If you find that the pan axis is balanced in some positions but in
others it tends to fall then you need to make a further adjustment by
rotating the top carbon fiber tube either left or right: