Summary of m18mt
Page 1
®.
Page 2
2 xray usa rcamerica, 167 turtle creek boulevard suite c dallas, texas 75207 usa phone: (800) 519-7221 * (214) 744-2400 fax: (214) 744-2401 email: xray@rcamerica.Com xray europe pred polom 762 91101 trenčín slovakia, europe phone: 421-32-7440180 fax: 421-32-7440179 email: info@teamxray.Com before yo...
Page 3
3 important notes – electrical • insulate any exposed electrical wiring (using heat shrink tubing or electrical tape) to prevent dangerous short circuits. • use a recommended charger for the receiver and transmitter batteries and follow the instructions correctly. Over-charging, incorrect charging, ...
Page 4
4 warranty a new, unused battery pack is guaranteed against manufacturer’s defects and workmanship. Any damage due to misuse by the user will be repaired at the user’s expense. Xray assumes no liability for damages that arise from use or misuse of the battery pack. Xmc 300r electronic speed controll...
Page 5
5 getting to know your micro truck • front bumper – protects the front end of the truck in the event of front collision • body posts – body posts support the body shell • body clip – small metal clips that go through the holes in the body posts, securing the body to the body posts • shock absorbers ...
Page 6
6 charging batteries before operating your micro truck for the fi rst time, you need to properly charge the receiver battery pack and the starterbox battery pack. Use the proper battery charger we strongly recommend using a high-quality peak-detection charger with automatic shut-off. The charger shou...
Page 7
7 decorating the body the micro truck body was hand-painted with premium-quality, high-gloss paint and several stickers were applied to the body. If you want to use the included rear wing, you must trim it fi rst. To install the wing on the m18mt monster truck make two holes in the rear of the body a...
Page 8
8 battery pack steering servo antenna wire receiver receiver speed speed control control motor motor receiver 1 ch 2 ch speed control motor installing the transmitter batteries your xt1 transmitter uses eight aa batteries. The battery tray is located at the base of the transmitter. 1. Remove the bat...
Page 9
9 xt1 transmitter controls transmitter antenna transmits the radio signal from the transmitter. Always extend the transmitter antenna before you operate the transmitter; otherwise you risk create interference to another modeller. Transmitter crystal solid-state plug-in crystal allows you to change t...
Page 10
10 radio system terminology take some time to familiarize yourself with these radio system terms that are used throughout this manual. Bec (battery eliminator circuitry) bec circuitry powers the receiver and steering servo from the main battery pack. This eliminates the need for using a separate rec...
Page 11
11 1. 1 turn the transmitter steering wheel left then right to check if the front wheels move correctly. The amount of steering varies according to the steering wheel movement. If the steering wheel is turned all the way left or right, the front wheels will also steer all the way right or left. Oper...
Page 12
12 testing the range of the radio system it is important to test the range of the radio system before driving the micro truck. This will let you know if there is any interference in the signal between your transmitter and the truck, or if the batteries are low. It is best to perform a range test wit...
Page 13
13 to check the slip of the front differential, grab the right front wheel and hold the spur gear. Turn the left front wheel. You should be able to turn the wheel but with resistance. To check the slip of the rear differential, grab the right rear wheel and hold the spur gear. Turn the left rear whe...
Page 14
14 for adjusting the rear toe-in you have to purchase the #383302 adjustable turnbuckle set. Adjust rear toe-in by changing the length of the rear turnbuckles. Shortening the turnbuckle gives more rear toe-in; lengthening the turnbuckles give less rear toe-in. Make sure both rods are adjusted to the...
Page 15
15 shock mounting position you can change the shock mounting position by leaning the shocks at different angles, and also moving the shock closer or further from the centerline of the truck. You accomplish this by moving the shock top and bottom mounts to different locations on the shock towers and ...
Page 16
16 maintaining your m18t/mt micro truck your m18t/mt is designed to be easy to work on, and should require very little maintenance to keep it at its peak performance. To keep your micro truck running at optimal performance, you should periodically perform maintenance on the truck. General truck main...
Page 17
17 please note that the #389170 xms01mg xray micro servo is an analog servo and therefore it is required and necessary that you set your radio transmitter to standard response mode, not high response mode. If you set your radio to high response mode (or similar), you run the risk that the servo elec...
Page 18
18 never • this esc is designed to use with micro stock motors and micro motors up to 370 super size motors. Never use this esc with motors larger than 370 as you will ruin the esc. • never use this esc with brushless motors. • never run your model car in water, snow or wet conditions. This could re...
Page 19
19 if you transmitter does not feature these set-up functions, it is already in “basic set-up“ mode. • ensure that the esc is not connected to the drive battery, and is switched off. • remove the motor pinion, or ensure in some other way that the wheels of the model are free to rotate. • switch the ...
Page 20
20 important information symptom cause remedy steering servo works, but no motor function set-up / basic settings problem repeat basic esc set-up procedure from start; to store the function correctly you must hold full-throttle position while you press the set-up button. Note also that all transmitt...
Page 21
21 warning this is not a toy, it is a precision electronic speed controller. This product is not intended for use by children without direct supervision of a responsible, knowledgeable adult. Contents of box may differ from pictures. In line with our policy of continuous product development, the exa...
Page 22
22 #381172 graphite micro truck conversion set - silver #381171 graphite micro truck conversion set - blue #381173 graphite micro truck conversion set - black graphite micro truck conversion sets #383095 alu shock tower rear 7075 t6 (4mm) #385350 conversion alu wheel hubs for foam tires #388401 rear...
Page 23
23 #383302 adj. Turnbuckle set for toe-in adjustment #388192 xray spring front + rear - set medium #388191 xray spring front + rear - set soft-medium #388181 xray spring front + rear (4+4) - set soft #389936 orange #389939 yellow #389938 pink #389946 orange #389949 yellow #389948 pink #389622 micro ...
Page 24
Xray, k vÝstavisku 6992, 91101 trencin, slovakia, europe phone: +421-32-740 11 00, fax: +421-32-740 11 09, info@teamxray.Com xray, k vÝstavisku 6992, 91101 trencin, slovakia, europe phone: +421-32-740 11 00, fax: +421-32-740 11 09, info@teamxray.Com xray, k vÝstavisku 6992, 91101 trencin, slovakia, ...