Xray Nitro Micro NT18T Instruction Manual - page 45

45

THROTTLE LINKAGE ADJUSTMENT

c

m

y

k          

nt18t manual   page45

Idling Adjustment Screw.

Use to adjust the idle setting of the carburetor. 

Do not allow carburetor to close to less than 1mm.

• Turn on the transmitter and receiver and set the throttle servo trim to the neutral position.

• Adjust the idle adjustment screw on the carburetor to open approx. 2mm.

• Adjust both the throttle linkage and brake linkages accordingly.

• DO NOT adjust the linkage with the engine running.

FULL THROTTLE

• Adjust the servo-horn mounting position for the carburetor to open fully.

• Change the pivot mounting position on the servo horn in case the carburetor is not 

    opening fully or if it is opening excessively. Or if available on the transmitter, adjust 

    the throttle endpoint.

FULL BRAKE

• Adjust the brake rod collar so the brake works smoothly. 

• If the brake applies too much or not enough, adjust the brake rod collar accordingly. 

    Or if available on the transmitter, adjust the brake endpoint.

• To tighten brake, turn collar to thread brake rod INTO pivot. 

• To loosen brake, turn collar to thread brake rod OUT of pivot.

2mm 

Engine idling

NEUTRAL (IDLE)

2mm 

Engine idling