1. DL manuals
  2. Xstream
  3. Pressure Washer
  4. PE-5024HWEBGEN
  5. Operation Manual

Xstream PE-5024HWEBGEN Operation Manual

Summary of PE-5024HWEBGEN

  • Page 1

    Operation manual * important safety instructions * save these instructions.

  • Page 2: Table

    2 table of contents introduction 4 using the operators manual product identification 5 pressure washer 5 engine safety 6 understanding the machine safety decal 7 safety rules 7 hazard symbols and meanings gas washer components 14 component chart assembly 15 unpack the pressure washer 15 attach handl...

  • Page 3: Table

    3 table of contents introduction 4 using the operators manual product identification 5 pressure washer 5 engine safety 6 understanding the machine safety decal 7 safety rules 7 hazard symbols and meanings gas washer components 14 component chart assembly 15 unpack the pressure washer 15 attach handl...

  • Page 4

    4 using the operator’s manual the operating manual is an important part of your pressure washer and should be read thoroughly before initial use, and referred to often to make sure adequate safety and service concerns are being addressed. Reading the owner’s manual thoroughly will help avoid any per...

  • Page 5: Engine

    5 product identification record identification numbers pressure washer if you need to contact an authorized dealer or customer service line (1- 866-770-1711) for information on servicing, always provide the product model and identification numbers. You will need to locate the model and serial number...

  • Page 6

    6 safety important safety instructions save these instructions warning – when using this product basic precautions should always be followed, including the following: 1. Read all the instructions before using the product. 2. To reduce the risk of injury, close supervision is necessary when a product...

  • Page 7: For Outdoor Use Only

    7 understanding the machine safety labels the machine safety label shown below is placed on your machine to draw attention to potential safety hazards. Safety operating instructions/ instructions d’utilisation 1 • connect standard garden hose to unit (minimum size 5/8 i.D.). • relier un boyeau d’arr...

  • Page 8

    8 safety the safety alert symbol ( ) is used with a signal word (danger, caution, warning), a pictorial and/or a safety message to alert you to hazards. Danger indicates a hazard which, if not avoided, will result in death or serious injury. Warning indicates a hazard which, if not avoided, could re...

  • Page 9: Warning

    9 safety warning fuel and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death. When adding or draining fuel • turn pressure washer off and let it cool at least 2 minutes before removing fuel cap. Loosen cap slowly to relieve pressure in tank. • fill or...

  • Page 10: Warning

    10 safety warning starter cord kickback (rapid retraction) can result in bodily injury. Kickback will pull hand and arm toward engine faster than you can let go. Broken bones, fractures, bruises, or sprains could result. • never pull starter cord without first relieving spray gun pressure. • when st...

  • Page 11: Warning

    11 safety warning contact with muffler area can result in serious burns. Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire. • do not touch hot parts and avoid hot exhaust gases. • allow equipment to cool before touching. • keep at least 5 feet (1.5 m) of clear...

  • Page 12: Warning

    12 safety warning starter and other rotating parts can entangle hands, hair, clothing, or accessories. • never operate pressure washer without protective housing or covers. • do not wear loose clothing, jewelry or anything that may be caught in the starter or other rotating parts. • tie up long hair...

  • Page 13: Notice

    13 safety notice high pressure spray may damage fragile items including glass. • do not point spray gun at glass when using red 0° spray tip. • never aim spray gun at plants. Notice improper treatment of pressure washer can damage it and shorten its life. • if you have questions about intended use, ...

  • Page 14

    14 read this operator’s manual and safety rules before operating your pressure washer. Gas washer components 1. Spray tips detergent, 0°, 15°, and 40°: for various high pressure cleaning applications. 2. High pressure hose connect one end to water pump and the other end to spray gun. 3. Pressure con...

  • Page 15

    15 your pressure washer requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel. If you have any problems with the assembly of your pressure washer, please call the pressure washer help line. If calling for assistance, please have the model a...

  • Page 16: Warning

    16 pre-operation checklist follow the checklist below prior to using the machine each time 1. Check to ensure the engine oil is at the proper level. Use sae 10w30 oil 2. Check the 2 handle knobs to ensure they are tight and will not vibrate loose. 3. Add fuel to the gas tank. 4. Connect and tighten ...

  • Page 17: Notice

    17 starting your washer how to start your pressure washer to start your pressure washer for the first time, follow these instructions step-by-step. This starting information also applies if you have let the pressure washer sit idle for at least a day. 1. Place pressure washer near an outside water s...

  • Page 18: Warning

    18 6. Uncoil high pressure hose and attach quick connect end of hose to base of spray gun. Pull down on collar of quick connect, slide onto spray gun and let go of collar. Tug on hose to be sure of tight connection. 7. Similarly, attach other end of high pressure hose to high pressure outlet (a) on ...

  • Page 19: Warning

    19 starting your washer 10. Connect the garden hose to the water inlet. Tighten by hand. 11. To start the machine, locate the engine switch on the side of the engine, and switch it to the on position. (see component chart to locate switch) check to ensure fuel valve is in the on position and if star...

  • Page 20: Warning

    20 starting your washer warning starter cord kickback (rapid retraction) can result in bodily injury. Kickback will pull hand and arm toward engine faster than you can let go. Broken bones, fractures, bruises, or sprains could result. • never pull starter cord without first relieving spray gun press...

  • Page 21: Warning

    21 shutting down your washer warning contact with muffler area can result in serious burns. Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire. • do not touch hot parts and avoid hot exhaust gases. • allow equipment to cool before touching. • keep at least 5 fe...

  • Page 22

    22 read this operator’s manual and safety rules before operating your pressure washer. Electric washer components 1. On/off switch 2. Motor 3. Pump 4. Gfci 5. Power cord 6. Detergent hose 7. Adjustable unloader knob 8. Water outlet 9. Water inlet 10. High pressure hose 11. Gun/wand assembly 12. Quic...

  • Page 23: Warning

    23 power cord connection important safety instructions warning - when using this product basic precautions should always be followed, including the following: 1. Read all instructions before using product. 2. To reduce the risk of injury, close supervision is necessary when a product is used near ch...

  • Page 24

    24 power cord connection 1. Make certain the motor switch is in the “off” position. 2. Ensure electrical supply is identical to the specifications listed on the pressure washer data plate. 3. Grounding instructions: this product must be grounded. If it should malfunction or breakdown, grounding prov...

  • Page 25

    25 maintenance intructions caution: only certified electrician can service the motor. Contact the authorized dealer for service or additional information. User maintenance instructions: general inspection: inspect the motor at regular intervals, approxi- mately every 500 hours of operation or every ...

  • Page 26: Notice

    26 6. Uncoil high pressure hose and attach quick connect end of hose to base of spray gun. Pull down on collar of quick connect, slide onto spray gun and let go of collar. Tug on hose to be sure of tight connection. Starting your electric washer 4. Attach wand extension to spray gun. Tighten by hand...

  • Page 27: Warning

    27 warning the high pressure stream of water that this equipment produces can cut through skin and its underlying tissues, leading to serious injury and possible amputation. • never connect high pressure hose to nozzle extension. • keep high pressure hose connected to pump and spray gun while system...

  • Page 28: Warning

    28 important: before starting the pressure washer, be sure you are wearing adequate safety goggles. Warning risk of eye injury. Spray can splash back or propel objects. • always wear safety goggles when using this equipment or in vicinity of where equipment is in use. • before starting the pressure ...

  • Page 29: Warning

    29 how to shut down your pressure washer 1. Release spray gun trigger. 2. Turn the motor switch to the off position. 3. Always point spray gun in a safe direction, squeeze spray gun trigger to release retained high water pressure. Important: spray gun traps high water pressure, even when motor is st...

  • Page 30: Warning

    30 how to use spray tips the quick–connect on the nozzle extension allows you to switch between four different quick connect spray tips. Spray tips can be changed while pressure washer is running once spray gun trigger safety lock is engaged. The spray tips vary the spray pattern as shown above. Fol...

  • Page 31: Notice

    31 to apply detergent, follow these steps: 1. Review use of spray tips. 2. Prepare detergent solution as required by job. 3. Place small filter end of detergent siphoning tube into detergent container. Note: make sure the filter is fully submerged in detergent while applying detergent. This washer w...

  • Page 32: Troubleshooting Chart

    32 troubleshooting problem cause correction unit has following problems: failure to produce pressure, erratic pressure, chattering, loss of pressure, low water volume. 1. Low pressure spray tip installed. 2. Water inlet is blocked. 3. Inadequate water supply. 4. Inlet hose is kinked or leaking. 5. C...

  • Page 33

    33 engine will not start; or starts and runs rough 1. Low oil level 2. Dirty air cleaner 3. Out of gasoline 4. Stale gasoline 5. Spark plug wire not connected to spark plug 6. Bad spark plug 7. Water in gasoline 8. Overchoking 1. Fill crankcase to proper level 2. Clean or replace air cleaner 3. Fill...

  • Page 34: Winter Storage

    34 storage winter storage to protect the unit from freezing temperatures: . 1. Use pump saver to treat pump. This minimizes freeze damage and lubricates pistons and seals. Contact your local dealer for pump saver solution. 2. If pump saver is not available, connect a 3 ft. Section of garden hose to ...

  • Page 35: Notice

    35 storage note: pump saver is available as an optional accessory. It is not includ- ed with the pressure washer. Contact the nearest authorized dealer to purchase pump saver. To use pump saver, make sure the pressure washer is turned off and disconnected from supply water. Read and follow all instr...

  • Page 36

    If you need assistance with the assembly or operation of this pressure washer please call 1-866-770-1711.