XtendLan DPC-D247 User Manual

Summary of DPC-D247

  • Page 1

    Dpc-d247 2-wired door station user´s manual.

  • Page 2: Introduction

    Introduction the door station is designed with high resolution color ccd camera, it pro- vides wide angle of 105 0 for dt 2-wire intercom system. The high white led for night view makes the door station working efficiently at night. The front panel is made of medical stainless steel with a thickness...

  • Page 3: Door Station Mounting

    Lock control jumper: to select the lock type. Door station code dip: total 4 door stations can be supported. T/r+,t/r-: usb-rs485 communication terminal. Main connect port: to connect the bus line and the electronic locks. Bus: connect to the bus line, non-polarity. Pl:external lock power input, con...

  • Page 4: Placing Name Label

    Placing name label 90° open close 1 2 3 system wiring and connections l1 l2 pl s1+ s2+ s- - + monitor ac~ pc6 basic one-to-one connection steps: 1. Use the special spanner to move 90 0 to loosen the screw. 2. Open the front panel. 3. Insert the name plate -5-.

  • Page 5: Electric Lock Connection

    Electric lock connection door lock controlled with internal power connect one lock connect two locks note: 1. Electronic lock of power-on-to-unlock type should be used. 2. The door lock is limited to 12v, and holding current must be less than 250ma. 3. The door lock control is not timed from exit bu...

  • Page 6

    Lock take off the jumper power supply lock take off the jumper power supply lock bus pl s1+ s2+ s- bus pl s1+ s2+ s- connect one lock connect two locks 5.2.3 unlock parameter setting(set on monitor) 1.Touch item on main menu page. 2.Touch the screen anywhere and hold for 2s. 3.Touch installer setup ...

  • Page 7: Dip Switches Setting

    Dip switches setting the dip switch is designed to set the code for door station and monitor, there are two states for each dip switch, please refer to the sketch map. On(1) = off(0) = on on total 2 bits can be configured, bit-1 and bit-2 are used to assign id code for door sta- tion.The switches ca...

  • Page 8: Specification

    Bit state user code code=0 code=1 code=2 code=3 code=4 code=6 code=7 code=8 code=9 code=10 code=11 code=12 code=13 code=14 code=15 code=5 bit state user code bit state user code 1 2 3 4 5 6 on 1 2 3 4 5 6 on 1 2 3 4 5 6 on 1 2 3 4 5 6 on 1 2 3 4 5 6 on 1 2 3 4 5 6 on 1 2 3 4 5 6 on 1 2 3 4 5 6 on 1 ...