Summary of GONU14RS
Page 1
Gonu14rs gepon onu with catv and voip fxs user’s guide.
Page 2: Contents
Gonu14rs user’s manual www.Xtendlan.Com ii contents 1 product introduction ........................................................................................ 1 1.1 application scenario ............................................................................ 1 1.2 features ....................
Page 3
Gonu14rs user’s manual www.Xtendlan.Com iii 4.5 call return ........................................................................................ 30 4.6 redial when busy ............................................................................. 31 4.7 call waiting ................................
Page 4: 1 Product Introduction
Gonu14rs user’s manual www.Xtendlan.Com 1 1 product introduction the gonu14rs is a gepon onu terminal, which complies with the ieee 802.3ah standard and the ctc2.0 standard. The device provides one epon interface, four 10/100base-t ethernet interfaces, one catv rf connector, and two fxs voip interfa...
Page 5: Front Panel
Gonu14rs user’s manual www.Xtendlan.Com 2 g.711, g.726, g.729 voice coding rfc2833 dtmf t.38, g711 fax transparent pass-through mode special service of voip uart console port 1.3 led indicators and interfaces front panel figure 1 front panel led color status description power green on the device is ...
Page 6: Rear Panel
Gonu14rs user’s manual www.Xtendlan.Com 3 led color status description pon_los red blinks the receiving optical power of the onu is lower than the sensitivity of the optical receiver. Off the receiving optical power of the onu is normal. Phone_2/1 green on the phone is registered to the sip server. ...
Page 7
Gonu14rs user’s manual www.Xtendlan.Com 4 interface/button description reset hardware reset 1.4 product specifications item parameters specifications optical interface uplink/downlink transmission rate 1.25 gbps central wavelength uplink: 1310 nm downlink: 1490 nm catv: 1550 nm transmission di...
Page 8
Gonu14rs user’s manual www.Xtendlan.Com 5 item parameters specifications laser eye safety fda 21cfr 1040.10 and 1040.11 en (iec) 60825-1 en (iec) 60825-2 green standard rohs physical specificatio ns physical dimension l x w x h: 218 mm x 172 mm x 41 mm weight 580 g 1.5 system requirements refe...
Page 9: 1.7 Safety Precautions
Gonu14rs user’s manual www.Xtendlan.Com 6 1.6 environment requirements item specifications operating temperature 0ºc~40ºc storage temperature -40ºc~75ºc operating humidity 10%~90%, non-condensing storage humidity 5%~95%, non-condensing power power adapter output: 10.8 v~13.2 v dc 1.7 safety precauti...
Page 10: Hardware Installation
Gonu14rs user’s manual www.Xtendlan.Com 7 ccca standard ieee802.3ah-2004 ieee802.3u ieee802.1q ieee802.1d ipv6 snmp v1/v2 sip rfc3261/3262/3263/3264/3265 g.711, g.726, g.729 voice coding rfc2833 dtmf t.38, g711 fax pass-through mode 2 hardware installation 2.1 power interface the gonu14rs uses speci...
Page 11: 2.3 Ethernet Interface
Gonu14rs user’s manual www.Xtendlan.Com 8 the onu has invisible internal laser, which may cause harm to eyes. During setup, avoid direct eye exposure to the optical interface of the onu, the fiber connector of the fiber line, or the uncovered area of the fiber. 2.3 ethernet interface the gonu14rs pr...
Page 12: 3 Web
Gonu14rs user’s manual www.Xtendlan.Com 9 no. Definition color 8 null brown table 2 pinout of crossover cable at ethernet rj-45 port no. Definition color 1 rxd+ green and white 2 rxd- green 3 txd+ orange and white 4 null blue 5 null blue and white 6 txd- orange 7 null brown and white 8 null brown 3 ...
Page 13: 3.2 Home Page
Gonu14rs user’s manual www.Xtendlan.Com 10 username: admin password: admin 3.2 home page the home page is as follows. Parameters in this page are described as follows: field description system uptime the interval since the last system start-up. Lan connection status of the lan interface. In this cas...
Page 14
Gonu14rs user’s manual www.Xtendlan.Com 11 field description provisioning status connection status of the provision. Voice service whether the voice service is started. If at least one phone is registered to the sip server, the value of this field is up. Otherwise, it is down. Port1 regstatus whethe...
Page 15: Ip Settings
Gonu14rs user’s manual www.Xtendlan.Com 12 ip settings unmanaged: do not configure the ip address information of the lan interface. Obtain an ip address automatically: obtain an ip address through dhcp from lan side. – ip address: the ip address obtained by dhcp. – netmask: the subnet mask obtained ...
Page 16
Gonu14rs user’s manual www.Xtendlan.Com 13 – lease time: the lease time of dhcp server. Enable dhcp relay: enable dhcp proxy function. Relay ip: the ip address of dhcp proxy. Server and relay off: disable dhcp server and dhcp proxy on the lan side. Service status – ip filter: the status of the ip fi...
Page 17
Gonu14rs user’s manual www.Xtendlan.Com 14 ppp settings: – username: user name of pppoe – password: password of pppoe – keep alive: keep alive time of pppoe. – authentication: select the authentication mode of pppoe. – mtu: maximum transmission unit of pppoe – mac: ethernet address of the wan inte...
Page 18
Gonu14rs user’s manual www.Xtendlan.Com 15 for setting the static ip address, see the following figure: static settings – ip address: set the ip address. – mask: set the subnet mask. – mac: ethernet address – restore: restore the default ethernet address..
Page 19
Gonu14rs user’s manual www.Xtendlan.Com 16 after setting the parameters, click apply to apply the settings immediately. Because the configuration is lost if the iad is powered off, you must click save all in the system command page from the tools menu. See the following figure: for obtaining ip addr...
Page 20
Gonu14rs user’s manual www.Xtendlan.Com 17 after setting the parameters, click apply to apply the settings immediately. Because the configuration is lost if the iad is powered off, you must click save all in the system command page from the tools menu. See the following figure: 3.4 advanced configur...
Page 21
Gonu14rs user’s manual www.Xtendlan.Com 18 3.5.1 provision configuration with the provision function, the iad can automatically upgrade configuration files and system image in the specified address. Click provisioning in the left pane and the provision configuration page appears: parameters are desc...
Page 22
Gonu14rs user’s manual www.Xtendlan.Com 19 field description provisioning profile base url storage path of the configuration file for upgrade. The value of this field can be http or tftp address. Image firmware base url storage path of the image file for upgrade. The value of this field can be http ...
Page 23
Gonu14rs user’s manual www.Xtendlan.Com 20 parameters are described as follows: field description reg_status register status of the channel. That is, whether the channel is registered to the sip server. Packet_time time of rtp packaging. The value can be 10 ms, 20 ms, or 30 ms. The default value is ...
Page 24
Gonu14rs user’s manual www.Xtendlan.Com 21 field description proxy_fqdn ip address or domain name of the sip proxy. Proxy_port port number of the sip proxy. Reg_fqdn ip address or domain name of the sip registered server. Reg_port port number of the sip registered server. Outb_fqdn ip address or dom...
Page 25
Gonu14rs user’s manual www.Xtendlan.Com 22 field description function, and the value indicates the specific time interval. Vad_enable enable voice activity detection (vad). Ec_enable enable echo cancellation. Mwi_state the status of mwi. Nway_conf enable multi-way conference. This function is not su...
Page 26: Configurations
Gonu14rs user’s manual www.Xtendlan.Com 23 field description call_waiting enable call waiting when working with cw_default. Mwi if this service is enabled and a notify message is received in the voice mailbox, you can hear intermittent dialing tone after picking up the receiver. Otherwise, you hear ...
Page 27
Gonu14rs user’s manual www.Xtendlan.Com 24 click save all to save all configurations. 3.6.2 restoring default configuration click system commands > tools and the following page appears:.
Page 28
Gonu14rs user’s manual www.Xtendlan.Com 25 parameters are described as follows. Field/button description provisioned parameters relevant voice configuration. Non-provisioned parameters other configuration parameters. Restore defaults restore the selected configuration to factory default configuratio...
Page 29
Gonu14rs user’s manual www.Xtendlan.Com 26 select the image file or configuration file for update and click update gateway. The update process is as shown in the following page:.
Page 30
Gonu14rs user’s manual www.Xtendlan.Com 27 after the upgrade is complete, the page shown in the following figure appears:.
Page 31
Gonu14rs user’s manual www.Xtendlan.Com 28 if you update the image file, the system automatically reboots after the update is complete. If you update the configuration file, you need to manually reboot the system..
Page 32: 4.1 Call Holding
Gonu14rs user’s manual www.Xtendlan.Com 29 4 voip – supplementary services feature codes of the supplementary services are as follows: supplementary service type feature code call transfer with no consultation #90 call transfer with third-party consultation #91 three-way conferencing - call return *...
Page 33: Call_Transfer.
Gonu14rs user’s manual www.Xtendlan.Com 30 (1) in the voice parameters page, enable call_transfer. (2) in the conversation, press the cradle to hold b. (3) press #90>+transferred number> to transfer the call. 4.3 call transfer with third-party consultation description: a and b are in a conversation....
Page 34: 4.6 Redial When Busy
Gonu14rs user’s manual www.Xtendlan.Com 31 4.6 redial when busy description: a calls b, b is busy, a hangs up, and waits for some time, and automatically calls b. Operation: (1) in the voice parameters page, enable repeat_dial. (2) perform an outgoing call and the other party is busy. Press #5> and ...
Page 35: 4.8.5 Do Not Disturb
Gonu14rs user’s manual www.Xtendlan.Com 32 4.8.2 call forwarding when busy description: this function forwards incoming calls to a preset number when the local party is busy. Operation: (1) in the voice parameters page, enable call forwarding. (2) pick up the phone and press *74>+forwarding number>,...
Page 36: Do_Not_Disturb.
Gonu14rs user’s manual www.Xtendlan.Com acronyms and abbreviations 33 (1) in the voice parameters page, enable do_not_disturb. (2) pick up the phone and press *78>, to activate the do not disturb function. (3) pick up the phone and hang up, to deactivate the do not disturb function. 4.9 anonymous ca...
Page 37
34 appendix a acronyms and abbreviations catv community antenna television epon ethernet passive optical network dba dynamic bandwidth allocation fec forward error correction fttb fiber to the building ftth fiber to the home igmp internet group management protocol olt optical line terminal onu optic...