Ivs-170bd ivs-170be net digital video server user’s guide.
Index version description ................................................................................................................................. 4 chapter 1 introduction ................................................................................................................... 5 c...
User manual of embedded net dvs thanks for purchase the products of our company. If you have any request or questions, please contact us immediately. This manual is applicable for ivs-170bd/be decoding video server this manual may contain some technically incorrect places or printing errors. This ma...
User manual of embedded net dvs version description version1.5: to be matched with version1.5 encoding dvr and dvs. Version1.4: to be matched with version1.4 encoding dvr and dvs. - 4 -.
User manual of embedded net dvs chapter 1 introduction ivs-170bd/be series video server adopts embedded real-time multi-task operation system (rtos) and embedded processor, which is completely independent of pc platform and, efficiently improves system performance. Firmware is burned in flash, makes...
User manual of embedded net dvs chapter 2 installation 2.1 hardware installation 2.1.1 installation steps 1. Open packing case, and check the integrity; 2. Take out things needed in installation; 3. Connect cables needed (video signal input cable, audio signal input cable, rs485 cable and cable for ...
User manual of embedded net dvs 2. Link indicator lamp; 3. Tx/rx indicator lamp; 4. Rs232 interface; 5. 4 sensor alarm input and 2 replay output interface; 6. Usb interface (reserved). Back panel： ivs-170bd rear panel ivs-170be rear panel interface instruction（from left to right in return） ： 1. For ...
User manual of embedded net dvs 2.3 the pin definition of physics interfaces 2.3.1 pin definition of rs-232 port the decoder has one rs232 standard serial interface, with rj-45 connector. Its pin definition is as follows (‘i’ means input, and ‘o’ means output): (1) when the rs232 interface of the dv...
User manual of embedded net dvs (2) 25-pin to 9-pin converter’s internal connection is like this: (3) if you don’t want to use 25-pin to 9-pin convertor to connect dvs and dte through rs232 interface, you must use rj45-db9 cable. Its internal connection description is: (4) when the rs232 interface o...
User manual of embedded net dvs the other is the db25 male connector. Below is the description of the internal connection between rj45 and db25: 2.3.2 pin definition of rs485 port pin5 ---- tx+/rx+ pin 6 ----- tx-/rx- 2.3.3 pin definition of ethernet port (1) pin definition of the direct network cab...
User manual of embedded net dvs (2) pin definition of the cross network cable connecting decoder and host pc: - 11 -.
User manual of embedded net dvs chapter 3 video server setup there are three kinds of methods to configure the parameters of video server. 1. Through hyper terminal (connect decoder with the pc through rs-232 serial ports) 2. Through client-end application software (connect decoder with pc through n...
User manual of embedded net dvs step2: to name the connection name and to define the icon. Input a name (e.G. Aa), select a icon, press “ok”, the dialogue box like fig. 3.1.2 appears. Fig. 3.1.2 select communication port step 3”: to select the communication port. Select “com1” communication port in ...
User manual of embedded net dvs fig. 3.1.4 hyper terminal interface step 5: to close the window, the fig. 3.1.5 will appear. Select “yes” and fig. 3.1.5 will appear. Select “yes” again to have the fig. 3.1.6 fig. 3.1.5 to disconnect fig. 3.1.6 save hyper terminal session step 6: save the hyper termi...
User manual of embedded net dvs 3.1.2 shell commands under hyper terminal port. Please use the dte cable and the db9/db25 convertor to connect pc with dvs rs-232 step 1: enter into the hyper terminal. Click “ start”→ “programs”→ “accessories”→ “communications”→ “hyper terminal”→ “aa.Ht”, the hyper t...
User manual of embedded net dvs getip function：to get the fixed ip, subnet mask, gateway, command port, ip address of pppoe dialup (the ip address of pppoe will be 0.0.0.0 if there is no dialup or dialup is not successful). Parameter: none. Grammar format: enter after input the command explanation: ...
User manual of embedded net dvs 3.2 ptz control step1: connect decoder rs-485 interface with ptz. Please refer to rs-485 pin definition. Dvs just uses pin5 (tx+) and pin6 (tx-) to send ptz control command. Step2: you can use remote client software to setup ptz protocol. In client software remote set...
User manual of embedded net dvs chapter 4 upgrade firmware there are two methods to upgrade the decoder firmware. One is using shell commands to ask decoder to download firmware from ftp server. The other is using pc client software. 4.1 use shell command and ftp server 1. Using dte cable to connect...
User manual of embedded net dvs the firmware from ftp server. - 19 -.
User manual of embedded net dvs 4.2 use client software to upgrade firmware in the system setup dialog of dvrdvs client software (refer to client software user manual), there is a button named “upgrade”: select the dvrdvs, click “upgrade” button, the following dialog box will be appeared: fig.4.21 r...
User manual of embedded net dvs chapter 5 frequent ask questions 1, failure to control ptz it is possible that the camera and equipment are not connected through rs485 port, or the wrong configuration of the decoder. 2，certain individual channel picture is un-normal please check whether the video ca...
User manual of embedded net dvs appendix a ivs-170bd specifications model name ivs-170bd decoder hardware decoding resolution pal: 704*576(4cif) ntsc: 704*480(4cif) pal: 528*384(dcif) ntsc: 528*320(dcif) pal: 704*288(2cif) ntsc: 704*240(2cif) pal: 352*288(cif) ntsc: 352*240(cif) pal: 176*144(qcif) n...
User manual of embedded net dvs appendix b ivs-170be specifications model name ivs-170be encoder & decoder compression standard h.264 compress resolution pal: 704*576(4cif) ntsc: 704*480(4cif) pal: 528*384(dcif) ntsc: 528*320(dcif) pal: 704*288(2cif) ntsc: 704*240(2cif) pal: 352*288(cif) ntsc: 352*2...
User manual of embedded net dvs appendix c good list 1. One piece of ds- 6000di or ivs-170be decoding server; 2. A cd contains client application; 3. One power supply voltage stabilizer 4. A 220v power cable; 5. A cable connecting rs232 with dte; 6. A dte cable - 24 -.
