YachtSafe G31 User Manual - Sms Communication
wireless alarm and control solutions
R
Version 01 l VETEL AB l info@vetel.se l www.yachtsafe.se l Gothenburg l Sweden
SMS communication
Set the cell phone number to be alarmed
To activate the alarm you have to send the folowing SMS to the telephone
number of the alarm:
Pin Configure Pin Alarm number1 (Alarm number 2)
Note that the alarm unit needs to be connected to a voltage source
to be able to communicate with it. You see an example to the right
about how
Communicate with the alarm
SMS-commands are sent from cell phones to the telephone number
of the alarm unit. All commands start with the alarm unit’s four numbered
pincode, space and the name of the SMS-command. One or several
parameters separated by space may also follow. Uppercase or lowercase
letters can be mixed. All SMS-commands respond with an SMS from
the alarm unit.
Description
Activate/Deactivate theft- and burglary protection.
Configure the alarm unit with one or two alarm receivers and
eventually new pincode.
Read current GPS-position with map link.The parameter
NEXT can be used when there is bad GPS-coverage, then the
alarm unit does not respond until a new position is available.
Activate/deactivate output or use it as a siren (only YachtSafe
Boat Alarm).
The alarm unit shuts down after the external power supply is
disconnected.
Read status information like battery voltage, etc.
Activate/Deactivate monitoring of the external driving volt-
age. Trigger level must be in step of 0.1V (for example 110 =
11.0 volt).
SMS commands
Pin ALARM On/Off
Pin CONFIGURE NewPin AlarmNumber1 (AlarmNumber2)
Pin GPS (NEXT)
Pin OUT NotUsed/On/Off/Siren
Pin SHUTDOWN
Pin STATUS
PIN VOLTAGE TRIGGER TriggLevel/Off
Summary of all SMS commands
See website for further information about SMS communication