Yaesu FL-2000B Instruction Manual - page 3
SPECIFICATIONS
Circuit
: Grounded Grid Class B
Frequency Coverage
: Ham bands 80 through 10 meters
Plate Input
: 1200 Watts PEP, 1000 Watts CW and 600 Watts AM
Plate voltage
: 2400 Volts DC
Drive Requirement
: 100 Watts PEP
Input Impedance
: 50 ohms, unbalanced
Output Impedance
: 50 - 75 ohms, unbalanced
Third Order Distortion
: 30 db or better at 1000 Watts PEP
Tube Complement
: 2 x 572B/T160
Cooling
: Forced-air cooling
Power Requirements
: AC 100, 1 10 Volts 50/60Hz 17 Amps
AC 200, 220, 230 Volts 50/60Hz 9 Amps
Dimensions
: 14
1/2
" Wide, 6
1/4
" High, 11
1/2
" Deep
Weight
: 44 Ibs
FRONT PANEL CONTROLS
POWER - OFF
: Rocker switch turns power on
OPER - TUNE.
: Rocker switch applies Bias when standby and relay
is disengaged.
SWR - IP
: Rocker switch selects either SWR or plate current
meter reading.
F - R
: Rocker switch selects either forward or reflected
SWR bridge reading.
SENS
: Potentiometer adjusts meter sensitivity for SWR
measurement.
PLATE
: Plate capacitor in tank circuit.
INSTALLATION
The FL-2000B has been designed incorporating two safety locks to prevent
dangerous high voltage shock. However, extreme care is recommended when
servicing inside the cabinet
.
- 2
–
Downloaded by
Amateur Radio Directory