Yaesu FRG-100 Technical Supplement - Main
Case Disassembly & Circuit Board Access
Main
Turn off the
and disconnect all
bles.
the set on a stable work surface, and
remove the 8 screws affixing the top cover
(Figure
Figure 1.
Carefully remove the top cover, paying
attention to the wire connecting the loud
speaker to the main unit. The plug
be
removed from the
on the main board
if desired (remember to reconnect before
the top cover
exposes the
component side of the Main Unit.
To remove the main unit, remove the 8 screws
affixing the unit and the screws affixing the
antenna terminal and
EXT DC
connector on
the rear
(Figure 2).
Figure 2.
0
To access the local unit, remove the 8 screws
affixing the bottom cover (Figure 3).
Figure 3.
To remove the local unit, remove the 7 screws
affixing the unit, and the 2 screws used on the
CAT connector on the rear
This
poses the component side of the
Unit
(Figure 4).
Figure 4.
2-l
00
Supplement