1. DL manuals
  2. Yaesu
  3. Processor
  4. FT-2000D - UPDATE V0150 AND V11.54
  5. Update Manual

Yaesu FT-2000D - UPDATE V0150 AND V11.54 Update Manual

Summary of FT-2000D - UPDATE V0150 AND V11.54

  • Page 1

    4/05/10 pep2000 this procedure is used to update main cpu ver. 0150 and edsp ver. 11.54 the flash programming for the ft-2000/d transceivers. We recommend installing the flash programming software on a pc computer with windows 2000, xp or vista operating system; and use the ct-119 programming cable ...

  • Page 2

    Ver. 0150 main cpu implements improvements (also includes all previous updates): • the fh-2 [ ][ -> ] keys are made to increment the frequency at 100khz up or down. • cw carrier is corrected to change lsb ⇔ usb when the indication is changed on vfo b. • correct the cw auto mode. • dmu band scope dis...

  • Page 3

    Main software update this procedure is used for uploading new software into the ft-2000/d amateur transceivers using the ct-119 program cable. If you have the 8pin mini-din pgm-sw (p0091526) refer to the 8-pin mini-din pgm-sw page 4. *don't forget to write down (or save to a cf card) any personal me...

  • Page 4

    (7) when the loading process is complete, an [ok?] box will appear. Click [ok?]. (8) turn off the main power switch, (or turn off the power supply for ft-2000d and wait a minute, until the capacitors discharge) and unplug the ac power cord. (9) unplug the ct-119 from the radio. (10) plug the ac powe...

  • Page 5

    3. Reconnect the power cord and turn on the main power switch located on the back of the ft-2000 (or turn on the power supply for ft-2000d). 4. While holding the [dnr]＋[cont]＋[dnf] buttons, press the front power switch to turn the radio on. You will see [ dsp prg no 1 ] on the radio display. 5. On y...

  • Page 6

    Note: we recommend trying the new factory default settings rather than transferring your old ones, because of the changes in the edsp and the main cpu, you may wish to make new settings. We hope this new software will increase your enjoyment of your ft-2000/d. Thank you for choosing yaesu radios. If...

  • Page 7

    Addendum if the ct-119 programming cable or 8-pin mini-din pgm-sw (p0091526) is not available you will need a serial cable rs-232c, db9f to db9f straight cable. Please follow these instructions. Main software update *don't forget to write down (or save to a cf card) any personal menu settings you ha...

  • Page 8

    (7) now go to the desktop open pep2000_main folder and find the fsw003 icon as shown below. Double-clickthe fsw003icon, displayed on the program screen. (8) when the program opens, confirm that the file ah025_v0150.Sfl is highlighted; if not, click on it to highlight it (9) click on [write] in the p...

  • Page 9

    Figure a remove the left rear foot (near the cat connector) to expose the program switch access hole. Switch s3004 is visible through the hole. Move the switch to the on (rear) position. (top of picture) this is just a screw hole for reference ..