1. DL manuals
  2. Yaesu
  3. Transceiver
  4. FT-410
  5. Operation Manual

Yaesu FT-410 Operation Manual

Manual is about: HF/50 MHz transceiver

Summary of FT-410

  • Page 1

    Hf/50 mh z t ransceiver ft-410 o peration m anual yaesu musen co., ltd. Tennozu parkside building 2-5-8 higashi-shinagawa, shinagawa-ku, tokyo 140-0002 japan yaesu usa 6125 phyllis drive, cypress, ca 90630, u.S.A. Yaesu uk unit 12, sun valley business park, winnall close winchester, hampshire, so23 ...

  • Page 2: Able

    Page 2 ft-410 o peration m anual t able of c ontents front panel buttons and knobs ........................ 3 display indications ............................................. 6 rear panel jacks ................................................ 7 supplied mh-31b8 microphone ......................... ...

  • Page 3: Ront

    Page 3 ft-410 o peration m anual f ront p anel b uttons and k nobs 14.195.000 m-012 1 2 3 4 6 7 8 9 10 5 1. Meter button press this button to change the meter function in the transmit mode as follows. Po  alc  swr  po po: indicates the average power output level. Alc: indicates the relative alc v...

  • Page 4: Ront

    Page 4 ft-410 o peration m anual 14.195.000 m-012 16 11 12 13 15 14 17 18 19 20 22 21 23 11. Att button this button selects the att level. 12. Comp button this button turns the speech processor on and off. 13. V/m button this button toggles frequency control between vfo-a and the memory system. In m...

  • Page 5: Ront

    Page 5 ft-410 o peration m anual 14.195.000 m-012 26 35 36 27 28 2425 29 30 32 33 34 31 24. Split button press this button to activate split frequency operation between vfo-a, used for reception and vfo-b, used for transmission (or vice versa). 25. Mw button pressing this button copies the current o...

  • Page 6: Isplay

    Page 6 ft-410 o peration m anual d isplay i ndications 14.195.000 m-012 display 14.195.000 m-012 2 3 4 5 6 1 1. Information display : indicates the rf attenuator status (“on” or “off”) selected for operation by the [att] button. : indicates the noise blanker status (“on” or “off”). / / / / : display...

  • Page 7: Ear

    Page 7 ft-410 o peration m anual r ear p anel j acks 1 2 8 7 6 5 4 3 1. Dc in jack this is the dc power supply connection for the transceiver. Use the supplied dc cable to connect directly to the car battery or to a dc power supply, which must be capable of supplying at least 22 a @13.8 vdc. (viewed...

  • Page 8: Upplied

    Page 8 ft-410 o peration m anual s upplied mh-31 b8 m icrophone dynamic microphone mh-31 dwn fst up 2 3 4 5 1 6 1. Ptt switch press this switch to transmit, and release it to receive after your transmission is completed. 2. Dwn key press to tune down, hold to start scanning. 3. Fst (fast) key the fs...

  • Page 9: Ccessories

    Page 9 ft-410 o peration m anual a ccessories & o ptions s upplied a ccessories hand microphone (mh-31 b8 ) 1 pc p/n: m3090086a dc power cord with fuse 1 pc p/n: t9025225 fuse 1 pc p/n: q0000074 operation manual 1 pc warranty card 1 pc a vailable o ptions external automatic antenna tuner (for wire a...

  • Page 10: Nstallation

    Page 10 ft-410 o peration m anual i nstallation c onnection of a ntenna and p ower s upply the ft-410 is designed for use with any antenna system providing a 50 ohm resistive impedance at the desired operating frequency. Every effort should be made to ensure the impedance of the antenna system is as...

  • Page 11: Nstallation

    Page 11 ft-410 o peration m anual i nstallation caution do not position this apparatus in a location with direct exposure to sunshine. Do not position this apparatus in a location exposed to dust and/or high humidity. Do not expose the apparatus to dripping or splashing. Do not put objects with liqu...

  • Page 12: Nstallation

    Page 12 ft-410 o peration m anual g rounding the ft-410 transceiver, like any other hf communications apparatus, requires an effective ground system for maximum electrical safety and best communications effectiveness. A good ground system can contribute to station efficiency in a number of ways: it ...

  • Page 13: Nstallation

    Page 13 ft-410 o peration m anual i nstallation vl-1000 l inear a mplifier i nterconnection be sure that both the ft-410 and vl-1000 are turned off, then follow the installation recommendations contained in the illustration. Note please refer to the vl-1000 operating manual for details regarding amp...

  • Page 14: Nstallation

    Page 14 ft-410 o peration m anual i nstallation i nterfacing to o ther l inear a mplifier the t/r control line is a transistor “open collector” circuit, capable of handling positive amplifier relay coil voltages of up to +50v dc and current of up to 400 ma. If you plan on using multiple linear ampli...

  • Page 15: Asy

    Page 15 ft-410 o peration m anual e asy o peration 14.195.000 m-012 [power / lock] button [main dial] knob [mode] button [af] knob [rf/sql] knob [▼]/[▲] button r eceiving 1. Connect your antenna to the ant jack on the rear panel. 2. Connect the after-market dc power supply (or car battery) using the...

  • Page 16: Asy

    Page 16 ft-410 o peration m anual e asy o peration r esetting the m icroprocessor the ft-410 has two reset methods. M enu m ode r eset use this procedure to restore the menu settings to their factory defaults, without affecting the memories you have programmed. 1. Press and hold in the [ power / loc...

  • Page 17: Eceiving

    Page 17 ft-410 o peration m anual r eceiving t uning s teps the tuning step of the [ main dial] knob on the operating mode. O perating m ode lsb/usb cw am data [main dial] 10 hz 10 hz 1 khz 10 hz pressing the [ fast] button will increase or decrease the tuning rate of the [main dial] knob by a facto...

  • Page 18: Eceiving

    Page 18 ft-410 o peration m anual r eceiving c larifier you may change the receiving frequency only without changing the transmit frequency. Here is the technique for utilizing the clarifier: 1. Rotation of the [clar] knob will allow you to modify your initial offset on the fly. Offsets of up to ±9....

  • Page 19: Onvenience

    Page 19 ft-410 o peration m anual c onvenience f eatures agc (t ool for c omfortable and effective r eception ) the agc system is designed to help compensate for fading and other propagation effects, with characteristics that can be of particular value on each operating mode. The basic objective of ...

  • Page 20: Onvenience

    Page 20 ft-410 o peration m anual c onvenience f eatures rf gain the rf gain controls provide manual adjustment of the gain levels for the receiver rf and if stages, to compensate for noise and/or signal strength conditions at the moment. The [ rf/sql] knob should, initially, be rotated to the fully...

  • Page 21: Tx P

    Page 21 ft-410 o peration m anual 14.195.000 m-012 [main dial] knob [mode] button [▼]/[▲] button 1. Press the []/[] buttons to select the operating band. By pressing the []/[] buttons, the operating band will change as follows. 7 10  14  15  18  21  24.5  28  1.8  3.5  7 ...... 2. Press...

  • Page 22: ) O

    Page 22 ft-410 o peration m anual the powerful cw operating capabilities of the ft-410 include operation using both an electronic keyer paddle and a “straight key” or emulation thereof, as is provided by a computer-based keying device. S etup for s traight k ey ( and s traight k ey emulation ) o per...

  • Page 23: Cw M

    Page 23 ft-410 o peration m anual cw m ode o peration u sing the b uilt - in e lectronic k eyer before starting, connect your keyer paddle to the front panel key jack in the status that turned off the [power / lock] switch. 1. Press the []/[] buttons to select the operating band. By pressing the [...

  • Page 24: Emory

    Page 24 ft-410 o peration m anual m emory o peration c onvenient m emory functions the ft-410 contains 120 regular memories, labeled “mx001” through “mx120”, one special programmed limit memory pairs, labeled “scanl/scanu”, one alaska emergency frequency channel (5167.5 khz), and five 60-meter (5 mh...

  • Page 25: Emory

    Page 25 ft-410 o peration m anual m emory o peration r egular m emory o peration erasing memory channel data 1. Press the [ v/m] button, if necessary, to enter the memory mode. 2. Rotate the [ main dial] knob to select the memory channel that you would like to erase. 3. Press and hold the [m-clr] bu...

  • Page 26: Canning

    Page 26 ft-410 o peration m anual s canning o peration you may scan either the vfo or the memories of the ft-410, and the radio will halt the scan on any station with a signal strong enough to open the receiver’s squelch. Vfo and m emory s canning preparation when operating the scanning feature, set...

  • Page 27: Peration

    Page 27 ft-410 o peration m anual o peration on a laska e mergency f requency : 5167.5 k h z (u.S. V ersion o nly ) section 97.401(d) of the regulations governing amateur radio in the united states permit emergency amateur communications on the spot frequency of 5167.5 khz by stations in (or within ...

  • Page 28: Pecifications

    Page 28 ft-410 o peration m anual general rx frequency range: 30 khz - 30 mhz (operating) 160 - 10 m (specified performance, amateur bands only) tx frequency ranges: 160 - 10 m (amateur bands only) frequency stability: ±1 ppm/hour (@+25 °c, after warmup) operating temperature range: 14 °f ~ 122 °f (...

  • Page 29: Pecifications

    Page 29 ft-410 o peration m anual s pecifications receiver circuit type: double-conversion superheterodyne intermediate frequencies: 67.899 mhz / 24 khz sensitivity (ipo “off”, att: off): ssb/cw (2.4 khz, 10 db s+n/n) 0.25 µv (0.5 - 1.8 mhz) 0.25 µv (3.5 - 30 mhz) 0.20 µv (50 - 54 mhz) am (6 khz, 10...

  • Page 30: Fcc N

    Page 30 ft-410 o peration m anual fcc n otice 1. Changes or modifications to this device not expressly approved by yaesu musen could void the user’s authorization to operate this device. 2. This device complies with part 15 of the fcc rules. Operation is subject to the following two conditions; (1) ...

  • Page 31

    Copyright 2015 yaesu musen co., ltd. All rights reserved no portion of this manual may be reproduced without the permission of yaesu musen co., ltd. Printed in japan http://www.Radioaficion.Com/hamfiles/.