Yaesu FT-891 Reference Book - Cat
FT-891 CAT Operation Reference Book
1
CAT
(Computer Aided Transceiver)
Operation
Overview
Connection
USB
USB
FT-891
Personal Computer
Commercially available
USB Cable
Figure 1
YAESU MUSEN does not produce CAT System
operating software due to the wide variety of
personal computers and operating systems in
use today. However, the information provided
in this chapter explains the serial data structure
and opcodes used by the CAT system. This
information, along with the short programming
examples, is intended to help you start writing
programs on your own. As you become more
familiar with CAT operation, you can customize
programs for your operating needs and utilize
the full operating potential of this system.
The CAT (Computer Aided Transceiver) System
in the
FT-891
transceiver provides control of
frequency, VFO, memory, and other settings such
as dual-channel memories and diversity reception
using an external personal computer. This allows
multiple control operations to be fully automated
with single mouse clicks, or keystroke operations
on the computer keyboard.
Using the USB Cable
(Refer to figure 1)
Note
: A USB driver is required for remote control
from a computer. Download the driver from
the Yaesu website (http://www.yaesu.com).
The
FT-891
transceiver has a built-in USB to Dual
UART Bridge, allowing direct connection from
the rear-panel USB jack to the USB jack of your
computer without the need of any external boxes.
You will need a USB cable to connect to the USB
jack on your computer.