Yakima FullBack Installation instructions manual - Attach Bottom Hooks
6
1035059C-5/42
• Not able to attach the bottom hooks? Use the Anchor
configuration. Follow Anchor installation instructions on page 6.
Attach bottom hooks
• REMOVE HOOkS BEFORE OPENING THE HATCH
OR TRUNk! Opening the hatch or trunk with
hooks installed could cause damage to the
vehicle.
• Acceptable attachment points may include the bottom edge of the trunk, hatch lid or
rear door. Additionally, the tie-down hooks underneath the vehicle or the metal ledge
of the bumper are acceptable. Only attach hooks to areas with sufficient support.
• You may need to attach hooks at a wider section of the seam and then slide
them into their recommended place on the vehicle.
• DO NOT ATTACH THE BOTTOM HOOkS TO PLASTIC OR TO
A SPOILER. Use the Anchor configuration instead. Follow
Anchor installation instructions on page 6.
• DO NOT ATTACH THE BOTTOM HOOKS TO GLASS.
Use the Glass Hatch Hooks (sold separately -
(Yakima Product Number 8002612).
PROCEED TO PAGE 7.
DID YOUR
FIT NOTES
INDICATE YOU NEED
TO USE ANCHORS FOR
THE BOTTOM HOOkS?
YES
NO