Yakima rackandroll 66 Operation And Assembly Manual - page 20
18
18
Install Center Rail - Check Light Plugs
Place Center Rail on top of Cross-members as
shown (picture
9A).
From the bag of bolts marked “T-Bolts,” insert
two T-Bolts into the bottom of each Cross-
member. Insert one at each end through
the enlarged slots at the ends of Cross-
members (picture
9B).
Line up the T-Bolts from each side and
lower the Center Rail Brackets over the
4 bolts (picture
9C).
With the Center Rail brackets over the
4 bolts, install flat washers and 17mm
nylock nuts. Before tightening nuts, use
a tape measure to make sure Center Rail
is centered between Side Rail.
Tighten (4) nuts to 23 ft. lbs.
(31N-m)
(picture 9D)
Check
Light Plugs:
Check the
plugs for
the taillights,
side lights,
and front
lights. Make
sure they are secured to lights and
not loose – see pictures page 11.
If the connectors have come loose
during shipping, please press them
firmly back into place. See page 4.
Connect (4) Deutsch Male/
Female Electrical Connectors.
See picture
9E (Center Rail) and 9F (Side Rail).
9E Center Rail Connectors Mated
9D Tighten to 23 ft. lbs.
9C Line up T-Bolts
9B T-Bolts inserted
9F Side Rail Connectors Mated
Unplugged
Plugged
In
Plug “clicks”
into place
9A Center Rail
in position
T-Bolt,
Flat Washer and
Nyloc Nut