Yakima RidgeBack 2 Installation Instructions Manual

Summary of RidgeBack 2

  • Page 1

    Ridgeback 4 ridgeback 2, 5 (not shown) zipstrip™ (6x) zipstrip™ (12x) zipstrip™ (15x) key (2x) front wheel strap (1) m5 wrench (1x) m4 wrench (1x) safety strap (1).

  • Page 2: Tubetop

    Purchase separately tubetop required for bikes with step-through/ladies frames or bikes with slanted top tubes. Part #8002531 tubetop handcuff hitchski hitchski (ridgeback 4&5 only) carries up to 6 pairs of skis or 4 snowboards part #8002418 handcuff adds a locking cable to carrier. Part #8002466.

  • Page 3: 1  ”

    1034500b-3/8 m4 m4 m5 m4 m5 1 ” 1/4 2” b c a 1 2 5 3 4.

  • Page 4

    A yakima tubetop (see cover page) may be required to carry your bike safely. Failure to load bikes properly can result in property damage, personal injury, or death. Bikes should be as level as possible to avoid ground clearance issues and possible ejections. Load largest or heaviest bike first. Alw...

  • Page 5

    1034500b-5/8 11 10 10 12 13.

  • Page 6

    1034500b-6/8 fold mast down to access the rear. B a b a 14 removal 1. Remove safety strap. 2. Unload the bikes. 3. Lower the arms. 4. Unlock the carrier. 5. Loosen red knob. 6. Remove the hitch pin. 7. Remove the carrier from the hitch. 8. Fold up the tongue. 9. Store ridgeback in a safe place. 15 b...