Yale EF-KIT1 Installation & Operation Manual - Door/window Contact Key Pad
4
Smoke Detector
1 Remove the cover and insert 3 x AA batteries.
2 The Smoke Detector will now enter into self-
calibration mode for 10 minutes (Do not touch
during this time). It will resume normal operation
after this period.
Panic Button
Remove the cover by loosening the fixing screw
and insert the CR2032 coin cell battery (supplied)
as shown (1). Ensure you observe battery polarity
and insert the battery under the two tabs and
click in to place (see insertion image, page 4).
Door/window contacts
1 Remove the cover of each door/window contact
by loosening the fixing screw.
2 Insert two AAA batteries into each detector as
shown. The indicator LED will flash briefly.
7
Keypad remote control
Remove the cover and insert the 3 AAA alkaline
batteries as shown. The ‘Tx’ LED will flash briefly
while components initialise.
Please note, the Home button on the operating
panel and the jumper switch inside (do not move)
have no function on this model.
Smoke detector accessory
Remove the cover and insert the four AAA
batteries as shown.
Keyfob remote control accessory
Slide off the battery cover, insert the
23A/MN21 battery as shown, and replace
battery cover. Switch to ‘on’.
Help button accessory
Remove the cover by loosening the fixing
screw and insert the 12V battery (supplied) as
shown. Please ensure you observe battery
polarity.
Tamper
switch
Jumper
switch
Tamper
switch
Jumper
switch
Magnet
Extension terminals
Learn/Test button
Learn/Test
button
On/Off switch
Key Fob
1 Open the battery compartment using a coin
by turning the cover in the direction of the big
arrow so the cover small arrow is next to round
dot.
2 Insert CR2032 coin cell battery and replace
cover.
/
5
Learn/Test
Button
LED
3
4
ale
Y
1
Panic/Learn
button
IMPORTANT
Insert the battery under the
two tabs and click into place.
Insert flat head screwdriver
to remove battery
Battery Removal and Insertion.