Yale RH10836AS Use, Care And Installation Manual

Summary of RH10836AS

  • Page 1

    Use, care, and installation guide model number: serial number: rh10836as rh10842as jun15.0101.

  • Page 3: Ble of Contents

    1 safety notice ................................................................. 2-3 list of materials ....................................................... 4 installation ducting calculation sheet ....................................... 5 mounting height & clearance ................................

  • Page 4: Important Safety Notice

    Important safety notice read and save these instructions 2 warning to reduce the risk of fire or electric shock, do not use this fan with any solid-state control device. Warning to reduce the risk of fire electric shock, or injury to persons, observe the following: a. Use this unit only in the manne...

  • Page 5: Important Safety Notice

    Important safety notice 3 warning to reduce the risk of fire, use only metal ductwork. Caution 7ruhgxfhulvnri¿uhdqgwrsurshuo\h[kdxvwdlurxwvlgh'rqrwyhqwh[kdxvwdlulqwrvsdfhvzlwklqzdoovfhlolqjv attics, crawl spaces or garages. Not for use over an outdoor grill. Operation $ozd\vohdyhvdihw\juloohvdqg¿owh...

  • Page 6: List of Materials

    List of materials 4 (3) wire nuts (1) suction cup (4) ø12 od / ø5 id washers (4) m6 x 1-1/2” wood srews (2) 3/16 x 1/4” machine screws (12) m3 x 5 machine screws (8) m4 x 8 machine screws (1) hardware package (1) 6” round damper (pre-installed) (4) 3/16 *1/2” mounting screws (pre-installed) (1 in ea...

  • Page 7: Installation –

    5 duct pieces total equivalent number length x used = 3- 1/ 4” x 10” rect., straight 1 ft. X ( ) = ft. 3- 1/ 4” x 10” rect. To 6” round transition 5 ft. X ( ) = ft. 3- 1/ 4” x 10” rect. To 6” round transition 90 0 elbow 20 ft. X ( ) = ft. 6”, 7”, 8”, 10” round, 90 0 15 ft. X ( ) = ft. 6”, 7”, 8”, 10...

  • Page 8: Installation –

    Installation – mounting height & clearance 6 ducting a minimum of 6” round duct must be used to pdlqwdlqpd[lpxpdluÀrzhi¿flhqf\ always use rigid type metal ducts only. Flexible gxfwvfrxoguhvwulfwdluÀrze\xswr use calculation worksheet to compute total duct zrun3djh always, when possible, reduce the nu...

  • Page 9: Installation –

    7 and installer. Warning fire hazard never exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside, unless using the recirculating option. Use single wall rigid metal ductwork only. )dvwhqdoofrqqhfwlrqvzlwkvkhh...

  • Page 10: Installation –

    8 installation – +rrg6shfl¿fdwlrq cl 35 7/8” , 41 7/8 ” 14” 3 15/16 ” 26 7/8 ” standard min. Ducted - 28” min. Recirc. - 30” max. - 41” rhex108s extension min. Ducted - 50 1/2” min. Recirc. - 54 1/2” max. - 79” 12” 4 5/8 " 2 3/16 " 6” top 12 3/8 " 9 1/2 ” 12 3/16 ” 7 1/16 ” front side.

  • Page 11: Installation –

    9 1 2 ceiling joists wood blocking top support frame support frame arm bottom support frame hood body blower housing 3 mounting screws (pre-installed) 4 installation – mounting the hood 'hwhuplqhprxqwlqjorfdwlrqrqfhlolqjdqgwhpsrudulo\wdshsdshuwhpsodwhlqfoxghgzlwkwkhkrrgwrwkhfhlolqj cut out internal ...

  • Page 12: Installation –

    10 installation – mounting the hood 1 2 4 3 5 top duct covers top support frame bottom duct covers bottom support frame thin trim piece thick trim piece ,qvwdoohohfwulfdodqggxfwzrun$fdeohorfnqrwvxssolhgpljkwehuhtxluhge\orfdofrghv),*( seal duct work with aluminum duct tape. 6. Power up hood, verify a...

  • Page 13: Installation –

    11 air diverter plate ductless recirculation is intended for applications where an exhaust duct work is not possible to be installed. When converted, the hood functions as a recirculating hood rather than an exhaust hood. Fumes and exhaust iurpfrrnlqjduhgudzqdqg¿owhuhge\dvhwrirswlrqdofkdufrdo¿owhuv7...

  • Page 14: Features & Controls -

    12 blower speed selection press to cycle through blowers speeds i, ii and iii blower on/off 1 lights bright/dim/off 3 3 lights bright/dim/off blower speed selection 2 delay off timer 4 blower on/off press to turn blower on and off. If lights are on they will also switch off when this button is press...

  • Page 15: Maintenance –

    13 surface maintenance: clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent or steel wool/scouring pads which will scratch and damage surface. For heavier soil use liquid degreaser. After cleaning it is recommended that you use non-abrasive stai...

  • Page 16: Maintenance -

    14 replacing light bulbs caution: light bulb becomes extremely hot when turned on. Do not touch bulb until switched off and cooled. Touching hot bulbs could cause serious burns. Make sure all power is turned off and bulbs are not hot. 5hpryhe\wxuqlqjexoefrxqwhuforfnzlvh1rwh%xoegrhvqrwxqvfuhzlwwxuqvg...

  • Page 17: Roubleshooting

    15 t roubleshooting troubleshooting procedures for rh108 issue cause what to do after installation, the unit doesn’t work. 1. The power source is not turned on. 1. Make sure the circuit breaker and the unit’s power is on. 2. The power line and the cable locking connector is not connecting properly. ...

  • Page 18: Iring Diagrams

    16 w iring diagrams rh10836as/rh10842as 3rzhufrqvxpswlrqvkrzqirughidxowpd[lpxp&)0eorzhufrq¿jxudwlrq cfm selector 390 cfm - fan max. 289w @ 2.6a cfm selector 290 cfm - fan max. 281w @ 2.4a.

  • Page 19: List of Parts &

    List of parts & accessories 17 description part# replacement parts /ljkw%xoe*8:hdfk =% optional accessories recirculating kit, rh10836as rhrk108s recirculating kit, rh10842as rhrk118s 5hsodfhphqw&kdufrdo)lowhuvhdfk 5+&) extension duct cover rhex108s order replacement parts from us by calling 1.888.7...

  • Page 20: Limited Warranty

    1-888-750-1698 staple your receipt here to obtain service under warranty or for any service related questions, please call: venting services (referred to herein as “we” or “us”) warrants to the original consumer purchaser (referred to herein as “you” or “your”) of range hoods (the “products”) that s...