1. DL manuals
  2. Yale
  3. Ventilation Hood
  4. RH70230AS
  5. Use, Care And Installation Manual

Yale RH70230AS Use, Care And Installation Manual

Summary of RH70230AS

  • Page 1

    Use, care, and installation guide model number: serial number: date of purchase: sales dealer: aug13.0201 rh70230as rh70236as rh70248as.

  • Page 3: Able of Contents

    1 safety notice ................................................................. 2-3 list of materials ....................................................... 4 installation ducting calculation sheet ....................................... 5 mounting height & clearance ................................

  • Page 4: Important Safety Notice

    Important safety notice read and save these instructions 2 warning to reduce the risk of fire or electric shock, do not use this fan with any solid-state control device. Warning to reduce the risk of fire electric shock, or injury to persons, observe the following: a. Use this unit only in the manne...

  • Page 5: Important Safety Notice

    Important safety notice 3 warning to reduce the risk of fire, use only metal ductwork. Caution to reduce risk of fi re and to properly exhaust air outside - do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces or garages. Operation always leave safety grilles and fi lters...

  • Page 6: List of Materials

    List of materials 4 models: rh70230as, rh70236as, rh70248as parts supplied 1 - hood 3 - baffl e fi lters (2 for rh70230as) 2 - halogen light bulbs (pre-installed) 1 - 10” round transition adapter 1 - top ducting cover plate 1 - hardware package hardware package contents parts not supplied - ducting,...

  • Page 7: Installation –

    5 installation – ducting calculation sheet duct pieces total equivalent number length x used = 3-1/ 4” x 10” rect., straight 1 ft. X ( ) = ft. 7”-10” round, straight 1 ft. X ( ) = ft. 3-1/ 4” x 10” rect.90 0 elbow 15 ft. X ( ) = ft. 3-1/ 4” x 10” rect.45 0 elbow 9 ft. X ( ) = ft. 3-1/ 4” x 10” rect....

  • Page 8: Installation –

    Installation – mounting height & clearance 6 ducting a minimum of 10” round duct must be used to maintain maximum air fl ow effi ciency. Always use rigid type metal ducts only. Flexible ducts could restrict air fl ow by up to 50%. Also use calculation (on page 5) to compute total available duct run ...

  • Page 9: Installation –

    7 warning fire hazard never exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside. Use metal ductwork only. Fasten all connections with sheet metal screws and tape all joints with certifi ed silver tape or du...

  • Page 10: Installation –

    8 installation – specifi cations top view side view back view ducting & electrical dimensions 12” 24” 4” 18” 8 9/16” 1 3/4” 1 1/16” 11 9/16” 6” 10 3/8” 14 3/16” 2 3/4” 9 15/16” 10 3/8” 4 5/16” 11 9/16” 10 3/4” 10 3/8” 14 3/16” 9 15/16” 1 11/16” 29 7/8” (30”) 35 7/8” (36”) 47 7/8” (48”) c/l c/l back ...

  • Page 11: Installation –

    9 electrical warning all electrical work must by performed by qualifi ed electrician or person with similar technical know how and background. For personal safety, remove house fuse or open circuit breaker before beginning installation. Do not use extension cord or adapter plug with this appliance. ...

  • Page 12: Installation –

    10 c/l c/l a b 16 7/8 ” min 26” 4” wood board installation – mounting the range hood 1. Select preferred ducting application (vertical or horizontal) and prepare hood. Refer to page 11 for dual blower horizontal ducting. 2. Plum and mark center line. 3. Choose desired height above cooking surface (2...

  • Page 13: Installation –

    11 installation – horizontal ducting conversion 1. Disconnect both blower plugs. 2. Remove (4) screws attaching dual blower plate to top of interior body of hood. Remove dual blower from hood body. A 3. Remove knock out plate a from back of hood body using fl at head screw driver and rubber mallet. ...

  • Page 14: Features & Controls –

    12 off off off 1 2 3 1 2 1 blower on/off/speed selection 2 lights dim/bright/off 1 blower on/off/speed selection 2 lights dim/bright/off rotate dial to change speed levels, (1) for low speed, (2) for medium speed and (3) for high speed rotate dial to change light settings, (1) for dim light and (2) ...

  • Page 15: Maintenance –

    13 surface maintenance: clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent, or steel wool/scouring pads which will scratch and damage surface. Do not use products containing chlorine bleach or orange cleaners. For heavier soil use liquid degrea...

  • Page 16: Maintenance –

    14 replacing light bulbs caution: light bulb becomes extremely hot when turned on. Do not touch bulb until switched off and cooled. Touching hot bulbs could cause serious burns. Make sure all power is turned off and bulbs are not hot. Remove by turning bulb counter clockwise. Note: bulb does not uns...

  • Page 17: Roubleshooting

    T roubleshooting 15 troubleshooting procedures for rh702 issue cause what to do after installation, the unit doesn’t work. 1. The power source is not turned on. 1. Make sure the circuit breaker and the unit’s power is on. 2. The power line and the cable locking connector is not connecting properly. ...

  • Page 18: Iring Diagrams

    16 rh70230as/rh70236as/rh70248as w iring diagrams.

  • Page 19: List of Parts and

    17 description part # replacement parts light bulb mr16 (gu10) 50w (each) z0b-0020 optional accessories back splash (30”) ak0710 back splash (36”) ak0716 back splash (48”) ak0718 12” duct cover (30”) ak0720 12” duct cover (36”) ak0726 12” duct cover (48”) ak0728 to order parts, please call us at 1.8...

  • Page 20: Arranty

    W arranty 1-888-750-1698 staple your receipt here to obtain service under warranty or for any service related questions, please call: venting services (referred to herein as “we” or “us”) warrants to the original consumer purchaser (referred to herein as “you” or “your”) of range hoods (the “product...