Yale SAA8021 User Manual - page 2
Product diagram
Battery installation
The battery compartment is located on the rear of the alarm
unit. It can be accessed by removing the screw from the
back of the unit and lifting the cover
Insert4‘AA’Alkalinesizebatteries(notincluded)asshown
(diagram). When the last battery is inserted the centre red
LEDwillflash3times.Replacethebackcoverandfixwith
screw.
NOTE: Please wait 30 seconds before inserting new batteries
whenever you take old batteries out.
1. Front ‘eyebrow’ contacts
2. LED
3. Siren
1. Battery compartment
2. Reset button
Installing the unit
The unit has been designed to be either free standing or wall
mounted.
To wall mount;
1. Place the alarm in the desired location
Care and maintenance
To clean the unit, simply use a soft, slightly damp with water,
cloth and wipe dry immediately.
Caution: Never use chemicals to clean the unit as this may
cause damage to the plastic and result in the alarm not
functioning.
Front
Back
Pairing the siren with another unit from the
range
The standalone alarm range has been designed specifically
to operate as single units or be paired together to work as
kits.
Up to 3 of the master units – those that have sensors as
well as sirens – can be paired together. The number of
slave units – those that do not have sensors – that will work
together is limitless.
This siren alarm is a slave unit.
Each master unit has a unique radio code, which can be sent
to any other unit in order to make them work together.
The procedure for doing this is as follows:
1. Starting with any master unit which you want to be
the main teacher unit for the system
2. Enter your PIN code and then press the Yale button
afterward.
3. The LED will flash in the sequence green, orange, red
4. Theunitisnowin‘sending’modeforthenext2
minutes. The green
and orange LED will
flash every second
5. Hold the rear metal
contact points of the
main unit against the
‘eyebrow’ contact
points of the learner
unit to which you are
pairing
6. To confirm the units
are paired, the
learner unit will have
Red LED on constantly (indicates
units in contact) and will beep once afterward. Only
release after you hear this beep.
7. Repeat this contact for all other learner units you want
to pair with the teacher unit
8. Afterthe2minutes‘sendingmodethemainunitwill
return to disarmed mode. The red LED will flash 3
times to confirm.
9. Ifyouwishtoexitthelearningmodewithinthe2
minute duration, press CLR button twice on
theteacherunittoexit.
1
2
3