Natural sound stereo integrated amplifier préampli/ampli de puissance stéréo de la série “natural sound” natural sound stereo-verstärker natural sound integrerad stereo förstärkare amplificatore integrato stereo a suono naturale amplificador integrado estéreo de sonido natural natural sound geïntegr...
This product complies with the radio frequency interference requirements of the council directive 82/499/eec and/or 87/308/eec. Cet appareil est conforme aux prescriptions de la directive communautaire 87/308/cee. Diese geräte entsprechen der eg-richtlinie 82/499/ewg und/oder 87/308/ewg. Dette appar...
English 1. To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transfo...
4 connections ● before attempting to make any connections to or from this unit, be sure to first switch off the power to this unit and to any other components to which connections are being made. ● when making connections between this unit and other components, be sure all connections are made corre...
English 5 connect the speakers terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wi...
4 select the speakers to be used. * if you use two speaker systems, press both the a and b switches. 5 play the source. 6 adjust to the desired output level. 7 if desired, adjust the bass, treble and balance controls or turn on the pure direct switch. (refer to page 8.) 3 select a desired input sour...
English 4 set the tape deck to be used for recording in the recording mode. 5 to monitor the sound to be recorded, select the tape deck being used for recording with the input selector. 1 select the source to be recorded. 2 play the source. 3 confirm the source by selecting it with the input selecto...
8 adjusting the bass and treble controls adjusting the balance control selecting the speaker system adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused from speaker location or listening room conditions. Because one or two speaker systems c...
English 9 remote control transmitter the remote control transmitter provided with this unit is designed to control all the most commonly used functions of the unit. If the cd player, tuner and tape deck connected to this unit are yamaha components, then this remote control transmitter will also cont...
10 notes about the remote control transmitter battery installation battery replacement if you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes ● use only aa, r6, um-3 batteries for replacement. ● be sur...
English 11 symptom the unit fails to turn on when the power switch is pressed. No sound. The sound suddenly goes off. Only one side speaker outputs the sound. There is a lack of bass, and no ambience. Sound “hums”. Using the bass, treble and balance controls does not affect the tone. The remote cont...
12 specifications minimum rms output power per channel 8 ohms, 20 hz to 20 khz, 0.03% thd ...................70w+70w 6 ohms, 20 hz to 20 khz, 0.06% thd ...................80w+80w dynamic power per channel (by ihf dynamic headroom measuring method) 8/6/4/2 ohms...........................................
Yamaha electronics corporation, usa 6660 orangethorpe ave., buena park, calif. 90620, u.S.A. Yamaha canada music ltd. 135 milner ave., scarborough, ontario m1s 3r1, canada yamaha electronik europa g.M.B.H. Siemensstr. 22-34, d-2084 rellingen bei hamburg, f.R. Of germany yamaha electronique france s....
