Yamaha AX-1090 Owner's Manual

Manual is about: Natural Sound Stereo Integrated Amplifier

Summary of AX-1090

  • Page 1

    Natural sound stereo integrated amplifier préampli/ampli de puissance stéréo de la série “natural sound” natural sound stereo-verstärker natural sound integrerad stereo förstärkare amplificatore integrato stereo a suono naturale amplificador integrado estéreo de sonido natural natural sound geïntegr...

  • Page 2

    ● remote control transmitter ● emetteur de télécommande ● fernbedienung ● fjärrkontrollsändare ● telecomando ● transmisor del control remoto ● afstandbediening ● batteries (size aa, r6, um-3) ● piles (taille aa, r6, um-3) ● batterien (größe aa, r6, um-3) ● batterier (storlek aa, r6, um-3) ● batterie...

  • Page 3: Features

    ● 145w + 145w (8 Ω ) rms output power, 0.01% thd, 20–20,000 hz ● high dynamic power, low impedance drive capability ● continuously variable loudness control ● pure direct switch to reproduce the purest source sound ● subsonic filter switch to cut out undesirable ultra- low-frequency signals ● pre ou...

  • Page 4: Connections

    4 connections ● before attempting to make any connections to or from this unit, be sure to first switch off the power to this unit and to any other components to which connections are being made. ● when making connections between this unit and other components, be sure all connections are made corre...

  • Page 5: Connecting Speakers

    5 english connect the speakers terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wi...

  • Page 6: Controls and Their Functions

    6 power volume natural sound stereo amplifier ax 1090 l6 l8 20 24 28 34 40 50 60 70 l4 l2 l0 8 6 4 3 2 l 0 –db l input tape 3 tape 2 aux tape 1 cd tuner phono pure direct speakers turnover frequency phones a on off b on off bass 5 5 4 3 3 2 2 l l defeat 4 400hz 200hz 2.5khz 5khz on off mono stereo t...

  • Page 7

    7 english 9 bass control used to increase or decrease the low frequency response. The defeat position produces flat response. 0 turnover frequency switches used to adjust the turnover point of the bass and treble controls respectively. This gives you flexible control over bass and treble response ch...

  • Page 8: Remote Control Transmitter

    8 remote control transmitter the remote control transmitter provided with this unit is designed to control all the most commonly used functions of this unit. If the cd player, tuner, tape deck and turntable connected to this unit are yamaha components designed for remote control compatibility, then ...

  • Page 9: Operations

    Power volume l6 l8 20 24 28 34 40 50 60 70 l4 l2 l0 8 6 4 3 2 l 0 –db input tape 3 tape 2 aux tape 1 cd tuner phono pure direct speakers turnover frequency phones a on off b on off bass 5 5 4 3 3 2 2 l l defeat 4 400hz 200hz 2.5khz 5khz on off mono stereo treble balance 5 5 4 3 2 l defeat l 2 3 4 lo...

  • Page 10: 3, 5

    10 1 select the source to be recorded. 2 play the source. 3 confirm the source by selecting it with the input selector and turning up the volume control. 4 set the tape deck to be used for recording in the recording mode. 5 to monitor the sound to be recorded (or being recorded), select the tape dec...

  • Page 11

    11 english adjusting the bass and treble controls adjusting the balance control selecting the speaker system adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused from speaker location or listening room conditions. Because one or two speaker ...

  • Page 12

    12 setting the subsonic filter switch open/close the control door when it is not necessary to operate controls inside the control door, close the door. To open the door to close the door using the pure direct switch you can enjoy the purest possible sound from your audio sources by setting this swit...

  • Page 13

    13 english notes about the remote control transmitter battery installation battery replacement if you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes ● use only aa, r6, um-3 batteries for replacement. ...

  • Page 14: Troubleshooting

    14 symptom the unit fails to turn on when the power switch is pressed. No sound. The sound suddenly goes off. Only one side speaker outputs the sound. There is a lack of bass, and no ambience. Sound “hums”. Sound level is low or sound is distorted while playing a record on the turntable. Using the b...

  • Page 15: Specifications

    15 english 15 specifications minimum rms output power per channel 8 ohms, 20 hz to 20 khz, 0.01% thd ..........................................145w+145w 6 ohms, 20 hz to 20 khz, 0.02% thd ..........................................185w+185w dynamic power per channel (by ihf dynamic headroom measuring...

  • Page 16

    Yamaha electronics corporation, usa 6660 orangethorpe ave., buena park, calif. 90620, u.S.A. Yamaha canada music ltd. 135 milner ave., scarborough, ontario m1s 3r1, canada yamaha electronik europa g.M.B.H. Siemensstr. 22-34, 25462 rellingen bei hamburg, f.R. Of germany yamaha electronique france s.A...