Owner’s manual mode d’emploi bedienungsanleitung bruksanvisning manuale di istruzioni manual de instrucciones gebruiksaanwijzing natural sound stereo integrated amplifier préampli/ampli de puissance stéréo de la série “natural sound” natural sound stereo-verstärker natural sound integrerad stereo fö...
This product complies with the radio frequency interference requirements of the council directive 82/499/eec and/or 87/308/eec. Cet appareil est conforme aux prescriptions de la directive communautaire 87/308/cee. Diese geräte entsprechen der eg-richtlinie 82/499/ewg und/oder 87/308/ewg. Dette appar...
1. To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, m...
4 connections • before attempting to make any connections to or from this unit, be sure to first switch off the power to this unit and to any other components to which connections are being made. • when making connections between this unit and other components, be sure all connections are made corre...
5 english connect the speakers terminals to your speakers with wire of the proper gauge, cut to be as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If th...
6 1 set to the “ ∞ ” position. 2 3 select a desired input source. * the indicator corresponding to the selected input source will illuminate. * note that pressing on each input selector button selects the source which is connected to the corresponding input terminals on the rear panel. 4 select the ...
7 english 1 select the source to be recorded. * to dub from tape to tape, refer to the “notes” shown at right. * when you select aux, tuner, cd or phono, be sure that tape 1 and/or tape 2 are not also selected. 2 play the source and then turn the volume control up to confirm the input source. 3 begi...
Using the cd direct switch you can enjoy the purest possible sound from your cd input source by setting this switch on. By doing so, the cd audio signal bypasses the bass, treble, balance and loudness controls, eliminating any alterations to the audio signal. When you listen with headphones connect ...
9 english remote control transmitter the remote control transmitter provided with this unit is designed to control all the most commonly used functions of the unit. If the cd player, tuner, turntable and tape deck connected to this unit are yamaha components, then this remote control transmitter wil...
10 notes about the remote control transmitter battery installation battery replacement if you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes ● use only aa, r6, um-3 batteries for replacement. ● be sur...
11 english if the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the symptom column, disconnect the power cord and contact your authorized yamaha ...
12 specifications minimum rms output power per channel 8 ohms, 20 hz to 20 khz, 0.04% thd....................55w+55w 6 ohms, 20 hz to 20 khz, 0.06% thd [except scandinavia model] .................................60w+60w dynamic power per channel (by ihf dynamic headroom measuring method) 8/6/4/2 ohm...
Yamaha electronics corporation, usa 6660 orangethorpe ave., buena park, calif. 90620, u.S.A. Yamaha canada music ltd. 135 milner ave., scarborough, ontario m1s 3r1, canada yamaha electronik europa g.M.B.H. Siemensstr. 22-34, d-2084 rellingen bei hamburg, f.R. Of germany yamaha electronique france s....
