Natural sound stereo integrated amplifier préampli/ampli de puissance stéréo de la série “natural sound” natural sound stereo-verstärker natural sound integrerad stereo förstärkare amplificatore integrato stereo a suono naturale amplificador integrado estéreo de sonido natural natural sound geïntegr...
2 ● remote control transmitter ● emetteur de télécommande ● fernbedienung ● fjärrkontroll ● telecomando ● transmisor del control remoto ● afstandbediening ● batteries (size aa, r6, um-3) ● piles (taille aa, r6, um-3) ● batterien (größe aa, r6, um-3) ● batterier (storlek aa, r6, um-3) ● batterie (dim...
3 english thank you for selecting this yamaha stereo amplifier. ● 60w + 60w (8 Ω ) rms output power, 0.04% thd, 20–20,000 hz ● high dynamic power, low impedance drive capability ● continuously variable loudness control ● cd direct amp switch to reproduce the purest cd sound ● remote control capabili...
4 1. T o assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers...
5 english notes about the remote control transmitter battery installation battery replacement if you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes ● use only aa, r6, um-3 batteries for replacement. ●...
6 connections never plug in this unit and other components until all connections are completed. ● when making connections between this unit and other components, be sure all connections are made correctly, that is to say l (left) to l, r (right) to r, “+” to “+” and “–” to “–”. Also, refer to the ow...
7 english connect the speakers terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wi...
8 controls and their functions front panel 1 standby/on switch press this switch to turn the power to this unit on. Press it again to turn this unit into the standby mode. Standby mode in this state, this unit consumes a very small quantity of power to receive infrared-signals from the remote contro...
9 english b speakers switches set the switch a or b (or both a and b) for the speaker system (connected to this unit) you will use to the on position. Set the switch for the speaker system you will not use to the off position. C tone controls bass used to increase or decrease the low frequency respo...
10 for control of this unit 1 sleep timer key this unit is automatically turned into the standby mode one hour after this key is pressed (so that sleep indicator lights up). 2 power key turns the power to this unit on and turns this unit into the standby mode alternately. 3 input selector keys selec...
11 english 1 set to the “ ∞ ” position. 2 turn the power on. 3 select a desired input source. The indicator for the selected source lights up. 4 select the speakers to be used. * if you use two speaker systems, press both the a and b switches. 5 play the source. 6 adjust to the desired output level....
12 to record a source to tape (or md) balance 5 5 4 3 2 l 0 l 2 3 4 l r loudness sleep aux tape md cd tuner phono tape 6 bass 5 5 4 3 3 2 2 l l 0 4 treble 5 5 4 3 3 2 2 l l 0 4 natural sound stereo amplifier ax 392 speakers phones a on b off volume input monitor cd direct amp l6 20 28 40 60 l2 8 4 2...
13 english adjusting the bass and treble controls adjusting the balance control selecting the speaker system adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused from speaker location or listening room conditions. Because one or two speaker ...
14 if the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the symptom column, disconnect the power cord and contact your authorized yamaha dealer o...
15 english specifications minimum rms output power per channel 8 ohms, 20 hz to 20 khz, 0.04% thd ...................60w+60w 6 ohms, 20 hz to 20 khz, 0.08% thd ...................70w+70w maximum output power (6 ohms, 1 khz, 10% thd) [china and general models only] ..................................1...
Yamaha electronics corporation, usa 6660 orangethorpe ave., buena park, calif. 90620, u.S.A. Yamaha canada music ltd. 135 milner ave., scarborough, ontario m1s 3r1, canada yamaha electronik europa g.M.B.H. Siemensstr. 22-34, 25462 rellingen bei hamburg, f.R. Of germany yamaha electronique france s.A...
