Natural sound stereo integrated amplifier préampli/ampli de puissance stéréo de la série “natural sound” natural sound stereo-verstärker natural sound integrerad stereo förstärkare amplificatore integrato stereo a suono naturale amplificador integrado estéreo de sonido natural natural sound geïntegr...
This product complies with the radio frequency interference requirements of the council directive 82/499/eec and/or 87/308/eec. Cet appareil est conforme aux prescriptions de la directive communautaire 87/308/cee. Diese geräte entsprechen der eg-richtlinie 82/499/ewg und/oder 87/308/ewg. Dette appar...
● 110w + 110w (8 Ω ) rms output power, 0.015% thd, 20–20,000 hz ● high dynamic power, low impedance drive capability ● continuously variable loudness control ● cd direct amplifier to reproduce the purest cd sound ● pure direct switch to reproduce the purest source sound ● subsonic filter switch to c...
4 connections ● before attempting to make any connections to or from this unit, be sure to first switch off the power to this unit and to any other components to which connections are being made. ● when making connections between this unit and other components, be sure all connections are made corre...
5 english connect the speakers terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wi...
6 operations to play a source 1 set to the “ ∞ ” position. 2 turn the power on. 3 select a desired input source. * if you select turntable as an input source (phono position), you should confirm that the phono (mm/mc) switch is set to the position corresponding to the type of cartridge being used by...
1 select the source to be recorded. 2 play the source. 3 confirm the source by selecting it with the input selector and turning up the volume control. 4 set the tape deck to be used for recording in the recording mode. 5 to monitor the sound to be recorded (or being recorded), select the tape deck b...
8 adjusting the bass and treble controls adjusting the balance control selecting the speaker system adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused from speaker location or listening room conditions. Because one or two speaker systems c...
9 english setting the subsonic filter switch when you listen with headphones connect the headphones to the phones jack. When listening with headphones privately, set both the speakers a and b switches to the off position. Open/close the control door when it is not necessary to operate controls insid...
10 remote control transmitter the remote control transmitter provided with this unit is designed to control all the most commonly used functions of the unit. If the cd player, tuner, turntable and tape deck connected to this unit are yamaha components designed for remote control compatibility, then ...
11 english notes about the remote control transmitter battery installation battery replacement if you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes ● use only aa, r6, um-3 batteries for replacement. ...
12 symptom the unit fails to turn on when the power switch is pressed. No sound. The sound suddenly goes off. Only one side speaker outputs the sound. There is a lack of bass, and no ambience. Sound “hums”. Sound level is low or sound is distorted while playing a record on the turntable. Using the b...
13 english specifications minimum rms output power per channel 8 ohms, 20 hz to 20 khz, 0.015% thd ...............................................110w+110w 6 ohms, 20 hz to 20 khz, 0.03% thd ...............................................130w+130w dynamic power per channel (by ihf dynamic headroom m...
Specificaties minimum rms uitgangsvermogen per kanaal 8 ohm, 20 hz tot 20 khz, 0,015% totale harmonische vervorming.........110w+110w 6 ohm, 20 hz tot 20 khz, 0,03% totale harmonische vervorming.........130w+130w dynamische vermogen per kanaal (ihf meetmethode voor vrij dynamisch bereik) 8/6/4/2 ohm...
