Yamaha CD Recordable/Rewritable Drive CRW-F1 Owner's Manual - page 20
Manual is about: Yamaha CD Recordable/Rewritable Drive Owner's Manual
of
54
Preparing the CRW-F1 Drive
11
Installing the CRW-F1 drive as an additional drive
Check the IDE channel (primary/secondary and master/slave) connecting the CRW-
F1 drive. (P. 12 – 14)
An empty 5 ¼-inch drive bay is required to install the CRW-F1 drive.
Replacing an existing IDE device with the CRW-F1 drive
Connect the CRW-F1 drive to the cable that was previously connected to the IDE
device.
When replacing a SCSI device such as a SCSI type CD-ROM drive, do not connect the
CRW-F1 drive to the cable that was previously connected to the SCSI device. Use a 40-
pin IDE cable to connect the CRW-F1 drive to the computer.
Note
Note
CRW-F1 drive
CRW-F1 drive
CD-ROM drive, etc.