Yamaha CRW4260T - CRW - CD-RW Drive User Manual

Manual is about: Yamaha CD Recorder User's Guide

Summary of CRW4260T - CRW - CD-RW Drive

  • Page 1

    Crw4260t series user guide guide de i’utilisateur bedienungsanleitung.

  • Page 2

    Fcc information (u.S.A.) 1. Important notice: do not modify this unit! This product, when installed as indicated in the instructions contained in this manual, meets fcc requirements. Modifications not expressly approved by yamaha may void your authority, granted by the fcc, to use the product. 2. Im...

  • Page 3

    T his output is value measured at a distance 200mm from the objective lens surface on the optical pick-up block. Ansi class : class 1 material : gaalas wavelength : 782-789 nm emission duration : continuous laser output power : less than 44.6 µ w* * laser diode properties caution use of controls or ...

  • Page 4: Warning

    Warning i ❢ warning ❢ • the temperature where crw4260t is located should be between 5ºc and 40ºc (41ºf – 104ºf), when used in a fan-cooled system. • do not disassemble the crw4260t cover to reduce the risk of electric shock. • always remove the disc before transporting crw4260t..

  • Page 5: Important Precautions

    Important precautions ii important precautions please read the following precautions before attempt- ing to operate the crw4260t. • before recording a disc, be sure to clean the disc and tray using an air aerosol-type dust remover. A dust particle on the disc may cause recording to fail, producing a...

  • Page 6: Table of Contents

    Table of contents iii table of contents introduction ............................................................................. 1 crw4260t features ...................................................... 1 orange book compatible recording ............................ 2 chapter 1 - system configura...

  • Page 7: Introduction

    Introduction 1 introduction thank you for purchasing a yamaha crw4260t drive. Please read this manual before using the drive in order to make the best use of the supe- rior crw4260t functions. After reading, please retain this manual for future reference. Crw4260t features ■ 2xs recording (rewritabl...

  • Page 8: Introduction

    Introduction 2 orange book compatible recording track at once in this mode, data can be recorded to disc one track at a time. Discs recorded in this mode cannot be played in cd players or cd-rom drives other than a cd-rw or cd-r drive until the session is closed. Multisession in this mode, data can ...

  • Page 9: Computer

    Chapter 1 - system configuration 3 chapter 1 - system configuration before using the crw4260t, make sure that you have all of the items on the list of included items. In order to use the crw4260t, you will require the following. Computer the following operating environment is required: • an ibm/at c...

  • Page 10: Tools

    Chapter 1 - system configuration 4 tools discs on the crw4260t, you can use conventional cd-rw and cd-r discs that conform to the recordable compact disc systems part 2 and part 3 (orange book). Yamaha recommends the following yamaha cd-rw and cd-r discs: cd-rw discs > crwm74r ( φ 120mm, 74 minutes)...

  • Page 11: Crw4260T Drive Settings

    Chapter 2 - installing the yamaha crw4260t drive 5 chapter 2 - installing the yamaha crw4260t drive crw4260t drive settings before installing the crw4260t in your computer, you will need to set the following jumpers. You set these jumpers by inserting jumper connectors into the jumper switch located...

  • Page 12

    Chapter 2 - installing the yamaha crw4260t drive 6 note: when you are using windows 95, and if the scsi id setting on the rear panel is the same as the number assigned to another scsi device, the plug and play component of windows 95 will automatically assign an unused number to the crw4260t (scam p...

  • Page 13

    Chapter 2 - installing the yamaha crw4260t drive 7 ♦ terminator setting the terminator setting indicates whether or not this device is the last connected scsi device. Terminator on (with a jumper) — use this setting if the crw4260t is the last device in the internal scsi daisy-chain. Terminator off ...

  • Page 14: Off

    Chapter 2 - installing the yamaha crw4260t drive 8 installing the crw4260t drive the following steps will differ slightly depending on the type of computer you are using. For details on removing the cover from your computer, and installing or removing internal devices, refer to the manual for your c...

  • Page 15

    Chapter 2 - installing the yamaha crw4260t drive 9 4. Remove the front cover of a vacant half-height drive bay. For details refer to the manual of your computer. 5. Remove the scsi card, and set the terminator setting of the scsi internal circuit to the position for internal connected devices. For d...

  • Page 16

    Chapter 2 - installing the yamaha crw4260t drive 10 8. Connect the audio cable. Connect the single 4-pin connector (sound blaster compatible) to the sound card. Connect the 4-pin connector at the other end of the cable (the larger connector) to the audio out connector on the crw4260t drive. The pola...

  • Page 17

    Chapter 2 - installing the yamaha crw4260t drive 11 9. Connect the power supply cable. Connect the +12v and +5v 4-pin power cable to the power supply interface located on the rear panel of the crw4260t drive. The shape of the connector makes it impossible to reverse the connections. 10. Tighten the ...

  • Page 18

    Chapter 2 - installing the yamaha crw4260t drive 12 12. Connect the power cable to an ac outlet, and switch on your computer. Make sure that the led located on the panel of the crw4260t drive is lit. 13. Start up your operating system. For the procedure, refer to the manual for your operation system...

  • Page 19: Chapter 3 - Operation

    Chapter 3 - operation 13 chapter 3 - operation front panel 1 disc tray the disc is inserted and ejected here. Pressing the eject button will open the tray. 2 headphone jack this stereo mini jack allows you to connect headphones and listen to audio. 3 headphone volume control this control adjusts the...

  • Page 20: Chapter 3 - Operation

    Chapter 3 - operation 14 loading a disc 1. Press the eject button to open the tray. 2. Carefully place the disc, label-side up, on the disc tray. 3. Press the disc tray softly or press the eject button again to close the disc tray..

  • Page 21: Chapter 3 - Operation

    Chapter 3 - operation 15 ejecting the disc if the crw4260t is powered on: press the eject button to eject the disc. Note: you cannot eject the disc if the scsi command prohibits the eject opera- tion while the crw4260t is reading data. Caution: be sure to remove the disc after it is completely eject...

  • Page 22: Chapter 3 - Operation

    Chapter 3 - operation 16 manual eject (emergency use) here we explain how to eject the disc when it cannot be ejected in the normal way; for example, the power is shut off inadvertently or the loading mechanism fails. This technique should be used only as a last resort. Frequent use may lead to malf...

  • Page 23: Troubleshooting

    Troubleshooting 17 troubleshooting if crw4260t is not performing as expected, look up the symptoms in the following table, and take the appropriate corrective action. Symptoms corrective action the power to the crw4260t is off • check the dc power cable connection. The power to the computer is off •...

  • Page 24: Appendix

    Appendix 18 specifications specifications are subject to change without prior notice. Interface scsi 2 data capacity 650mb (74 minutes) 550mb (63 minutes) record/read speed writing (cd-rw): 2x speed writing (cd-r): normal speed, 2x speed, 4xspeed reading: normal speed, 2x speed, 4x speed, 6x speed d...

  • Page 25: Appendix

    Appendix 19 front panel indicator key ● on: green ✦ flashing: green — off ❍ on: orange ✧ flashing: orange status on/disc read/write reset ❍ ➠ — ❍ ➠ — ready (no disc) ❍ — inserting disc ✦ ➠ ✧ — ejecting disc ✧ — ready (disc inserted) ● — seeking ● ✦ preparing to write ● ✧ writing ● ❍ writing (test mo...

  • Page 26: Japan

    Yamaha corporation electronic systems division printed in japan vz54190-2 english: if you have any questions, please contact your dealer or one of the following companies. French: pour plus de détails sur les produits, veuillez vous adresser à yamaha ou au distributeur le plus proche figurant dans l...