Yamaha DM2000 V2.1 Supplementary Manual

Page of 4

Download

Bookmark us

DM2000 V2.1 Supplementary Manual

DM2000 system software V2.1 contains the following changes from V2.0.

❏

MIX C-R SOURCES parameter added to

Control Room Monitor (page 159)

A “MIX C-R SOURCES” parameter has been added in the

CONTROL ROOM SETUP page. In V2.0, you could

choose one item from 2TR D1, D2, D3, A1, or A2 as a

monitor source, plus other sources (STEREO, ASSIGN1,

or ASSIGN2). In V2.1, you can turn the MIX C-R

SOURCES parameter off to disable this simultaneous

selection.

❏

MIX MONITOR SOURCES parameter

added to Surround Monitor (page 160)

A “MIX MONITOR SOURCES” parameter has been

added to the SURROUND MONITOR page. In V2.0, you

could choose ASSIGN1 or ASSIGN2 in addition to a BUS

as the monitor source, but in V2.1 you can turn this

parameter off to disable this simultaneous selection.

❏

THX presets added to Surround Monitor (page 161-163)

Presets for the THX pm3 monitor system have been added to the bass management settings for surround monitor-

ing. Several supplements have also been added regarding the surround monitor settings, so please replace the cor-

responding pages with the following.

Configuring Surround Monitoring

Surround monitoring, including speaker setup, monitor matrix, Bass Management, and monitor

alignment, is configured on the Surround Monitor Setup page.

Use the MONITOR [DISPLAY] button to locate the Surround Monitor Setup

page.

Use the cursor buttons to select the parameters, and use the Parameter wheel,

INC/DEC buttons, and [ENTER] button to set them.

Page 1
Dm2000 v2.1 supplementary manual dm2000 system software v2.1 contains the following changes from v2.0. ❏ mix c-r sources parameter added to control room monitor (page 159) a “mix c-r sources” parameter has been added in the control room setup page. In v2.0, you could choose one item from 2tr d1, d2,...
Page 2
Speaker setup: these parameters are for setting the volume balance of the surround monitor speakers. Select the osc (oscillator) parameter and choose from pink noise, 500-2k (pink noise through a 500 hz to 2 khz bpf), 1k (1 khz sinewave), or 50 hz (50 hz sinewave). Use the on/off button to turn the ...
Page 3
Hpf1–3: cut the low range so that the speakers’ supporting frequency ranges will not interfere with the sub- woofer signals. Hpf1–2: cut the high range so that the subwoofer’s supporting frequency ranges will not interfere with other speakers’ signals. You can set the bass management parameters in t...
Page 4
U.R.G., pro audio & digital musical instrument division, yamaha corporation © 2004 yamaha corporation [thxd] thx dvd this preset is configured for dvd-video production. Use this preset when mixing and/or monitor- ing audio content not from a theatrical film source. The parameters cannot be changed. ...