Yamaha EF4500iSE - Inverter Generator Installation And Operation Manual - page 8
page
8
1. Remove the screws from remote control transmitter, and
disassemble it.
2. Take out the dry cell batteries in the direction of a.
3. Insert new dry cell batteries from the direction of b.
Specifi ed dry cell battery : CR2032 (3.0 V) button cell battery
Quantity : 2
a
b
Transmit ID to the receiver unit
For the user who purchased only the remote control transmitter, need to transmit ID to the receiver after
"Installing procedure" page 4.
1
2
1. Remove the front panel and pull out the control panel .
(See "Installing procedure" page 2.)
2. Disconnect the short harness coupler.
3. Turn the engine switch to "ON".
4. Push "OFF" button 1 of the remote control transmitter
for longer than 0.5 seconds within 10 seconds. When this
operation is correct, indicator lamp 2 of the remote control
transmitter lights for approximately 1 second. And, the
startup signal is sent to the generator.
7XF-2819W-10̲0409.indd 8
7XF-2819W-10̲0409.indd 8
2008/04/10 9:18:18
2008/04/10 9:18:18