Yamaha FZ6-SS Assembly Manual - page 11
–7–
1
Band
2
V
1
Clutch cable
1
2
Clutch switch lead coupler
1
1
Windshield
1
C
2
Special nut
5
V
3
Screw
5
V
4
Windshield trims
2
C
NOTE:
WARNING
WARNING
CAUTION:
EAA00049
EAA00137
7. CLUTCH CABLE
A: Lubricate the pivoting part of
the clutch lever.
Recommended lubricants:
Yamaha cable lube or motor
oil
B: To install the clutch cable, be
sure to proceed as follows:
a. Turn in the adjuster on the lever
holder until tight. Next, align the
slit in the adjuster and cable
socket with the slit in the lever
holder.
b. Insert the cable end into the le-
ver hole. Next, while pulling the
outer cable in the direction op-
posite to the lever, seat the out-
er cable into the cable socket.
Check the clutch lever for smooth
action.
Refer to “ADJUSTMENTS AND
PREDELIVERY SERVICE”.
C: Install the clutch switch lead
coupler.
Proper cable routing is essen-
tial to assure safe motorcycle
operation.
Refer to “CABLE ROUTING”.
8. BAND
A: Clamp the left handlebar
switch lead.
B: Clamp the right handlebar
switch lead.
Proper cable routing is essen-
tial to assure safe motorcycle
operation.
Refer to “CABLE ROUTING”.
EAA00053
EAA00141
9. WINDSHIELD
The windshield is made of an
acrylate resin. Take care so that
it is not scratched.
A: Tighten the bolt to specifica-
tion.
Bolt:
0.4 Nm (0.04 m
Skg, 0.3 ftSlb)