Yamaha ICP1 Owner's Manual - page 6
6
ENGLISH
ICP1 Owner’s Manual
J
J
J
J
Installation Procedure
1
Connect the control panel unit and the ICP1 adaptor box.
Use an Ethernet "straight" cable.
• Do not use a "cross" cable to connect the control panel unit
and adaptor box. Also do not use joint connectors, cross cable
converters, or other extension adaptors.
• Connect ct the control panel unit and adaptor box directly, not
via a hub
.
• For maximum safety be sure to securely connect the ICP1
earth screw to an earth connection
.
2
Connect the adaptor box to a network hub or the DME64N/24N.
Use a "straight" cable for connection to a hub, or a "cross" cable for direct connection to the DME64N/24N.
n
• Use a 100Base-TX/10Base-T switching hub.
• When using category 5 UTP (Unshielded Twisted Pair) cable, the total length of the cables
connecting the control panel unit to the hub or DME64N/24N can be up to 100 meters. Due to
differences in cable and switching hub performance, however, proper operation at the maximum
length cannot be guaranteed in some cases. The maximum usable cable length will also be
reduced if joint connectors, cross cable converters, or other extension adaptors are used.
• Use STP (Shielded Twisted Pair) cable to prevent electromagnetic interference.
3
Connect the PA-300 AC adaptor to the adaptor box.
4
Plug the AC adaptor into an appropriate AC mains outlet.
Connection
ICP1
DC IN
ICP1 ADAPT
OR BOX
MADE IN JAPA
N
SCENE
HOME
ENTER
CANCE
L
F3
F2
F1
F4/UTIL
ITY
INTELL
IGENT
CONTR
OL PAN
EL
ICP1
F5
F6
1
3
4
2
DC IN
Control panel unit
To network hub or
DME64N/24N.
Cord hook.
To AC power outlet
ICP1 adaptor box
AC adaptor (PA-300)
Earth screw.
Control panel unit
CAUTION
WARNING
ICP1_E_D_F_S.book Page 6 Thursday, April 29, 2004 10:45 AM