Yamaha ME2000 Owner's Manual - page 7
Manual is about: memory expansion kit
of
9
6
ME2000
ENGLISH
4.
Remove the screws indicated in the illustration below: 10 screws from the left side, 10 screws
from the right side, 8 screws from the front, and 7 screws from the rear.
5.
Loosen the axis screws slightly (but do not remove them), so that the control panel can pivot.
6.
Hold onto the LCD, and lift up the rear of the control panel.
7.
Secure the raised control panel in place, so that it does not fall back down.
Do not remove the axle screws. If these screws are removed the control panel may fall and cause injury
or equipment damage.
Positioning
Screw
LCD
10 Screws
7 Screws
8 Screws
Positioning
Screw
10 Screws
Position-
ing Screw
Axis Screw
Axis Screw
Position-
ing Screw
LCD