1. DL manuals
  2. Yamaha
  3. Music Mixer
  4. MV12
  5. Owner's Manual

Yamaha MV12 Owner's Manual

Manual is about: Yamaha Mixer Owner's Manual

Summary of MV12

  • Page 1

    Mixer owner’s manual thank you for purchasing the yamaha mv12/6 mixer. The mv12/6 mixer is designed to provide the user with an ideal balance of operability, functionality, and simplicity. In order to get the most out of your mv12/6 mixer and its functions, and to enjoy years of trouble-free use, pl...

  • Page 2: Important

    Mv12/6 — owner’s manual fcc information (u.S.A.) 1. Important notice: do not modify this unit! This product, when installed as indicated in the instructions contained in this manual, meets fcc requirements. Modifications not expressly approved by yamaha may void your authority, granted by the fcc, t...

  • Page 3: Important

    Mv12/6 — owner’s manual important read the following before operating the mv12/6 important 1 warnings • do not place a container with liquid or small metal objects on top of this unit. Liquid or metal objects inside this unit are a fire and electrical shock hazard. • do not allow water to enter this...

  • Page 4: Features

    Mv12/6 — owner’s manual 2 mv12/6 features • the mv12/6 offers 12 input channels that can be mixed into stereo, monaural, or to four group outputs. • a monitor jack offers easy connection to a sub amp for monitor- ing. It allows monitoring of the main stereo output, tape in input and the signals from...

  • Page 5: Front & Rear Panels

    Mv12/6 — owner’s manual front & rear panels 3 q y t t o u e i i r r w channels 1-8 (monaural) channels 9-12 (stereo) response [db] +5 +10 +15 –15 –10 –5 0 frequency [hz] 10k 1k 100 20k 20 +20 –20 front & rear panels channel control section q gain control adjusts the input level of the signal enterin...

  • Page 6

    Mv12/6 — owner’s manual 4 front & rear panels y effect control controls the level of the signal sent from each channel to the effect bus. This control is located after the channel fader so its level will also be affected by the channel fader setting. When a stereo channel is used, l and r channel si...

  • Page 7: Master Control Section

    Mv12/6 — owner’s manual front & rear panels 5 q i !5 w !3 !0 e r !1 !4 !2 t o y u q st master fader controls the level of the signal that is sent to the st out jacks. W mono control controls the level of the signal (the monaural signal that is formed by combining the signals from the stereo bus) tha...

  • Page 8

    Mv12/6 — owner’s manual 6 front & rear panels u digital effect • program select switch selects a program from the built-in digital effects. Vocal echo 1 vocal echo 2 vocal echo 3 vocal echo 4 vocal reverb 1 vocal reverb 2 vocal reverb 3 vocal reverb 4 • parameter control controls parameters (effect ...

  • Page 9: Connector Panel

    Mv12/6 — owner’s manual front & rear panels 7 q input jacks (ch 1-8) both balanced xlr type and euro-block connectors are supplied. • xlr type (1:ground, 2:hot, 3:cold) • euro-block connectors ( : hot, : cold, g: ground) use input select switch to match the input to the type of mic or device connect...

  • Page 10

    Mv12/6 — owner’s manual 8 front & rear panels t send jacks • aux1, aux2 these are impedance balanced phone type output jacks with a nominal output/impedance of +4db/ 600 Ω. The aux1, 2 bus signals are output from their respective jacks. These jacks can be used to send the signal to monitor system su...

  • Page 11

    Mv12/6 — owner’s manual front & rear panels 9 !1 mono out jack this signal is the monaural mix of the stereo bus’s stereo signal. Its level is controlled with the mono control. Two types of jacks are provided; balanced xlr type and euro-block connectors. • xlr type (1: ground, 2: hot, 3: cold) nomin...

  • Page 12

    Mv12/6 — owner’s manual 10 front & rear panels ■ changing the connector panel’s location. The mixer allows attachment of the connector panel to either the rear or to the top-side of the mixer to provide optimum location of the connectors when installing the unit. The connector panel is attached on t...

  • Page 13: About The Accessories

    Mv12/6 — owner’s manual about the accessories 11 about the accessories euro-block connectors if you decide to use euro-block connectors, please use the supplied connectors and attach as shown in the illustration below. Q turn the power switch off. W loosen the screws holding the cover in place and r...

  • Page 14: Applications

    Mv12/6 — owner’s manual st out aux 1 send aux 2 (pre) send insert in insert out phones tape in rec out input mono out 12 applications applications example 1) basic setup procedure q connect line input devices or microphones to the input jacks and connect a power amp, that is connected to the main sp...

  • Page 15: Speakers

    Mv12/6 — owner’s manual st out aux 1 send aux 2 (pre) send phones tape in rec out input group out 1 2 3 4 applications 13 example 2) banquet room setup using independent speakers procedure q connect line input devices or microphones to the input jacks and connect a power amp, that is connected to th...

  • Page 16: Supplement

    Mv12/6 — owner’s manual frequency response 20hz—20khz +1db, -3db @+4db, 600 Ω (input gain control at minimum level) total harmonic distortion Ω hum & noise -128db equivalent input noise -95db residual output noise -64db (68db s/n) st out: master fader and one channel fader at nominal level, channel ...

  • Page 17

    Mv12/6 — owner’s manual supplement 15 ■ input specifications input input gain input nominal input level connector type connectors select switch control impedance impedance sensitivity *1 nominal max. Before clipping mic (+48v) -60 -80 db (0.078mv) -60 db (0.775mv) -40 db (7.75mv) mic 50-600 Ω input ...

  • Page 18: Dimensions

    Mv12/6 — owner’s manual 16 supplement 192 308 482 18.7 units: mm dimensions.

  • Page 19: Block and Level Diagrams

    Mv12/6 — owner’s manual supplement 17 ch input 1~4ch input [-60~+10db] insert out [0db] pad ha gain [-60db~-16db] [-34db~+10db] [0db] lo mid hi 3-stage eq peak ch.Fader [-10db] ba [0db] [0db] 1-2 3-4 st [-6db] pan post aux1 aux2 effect insert in [0db] mic(+48v) mic line +48v ba ch input 5~8ch pad st...

  • Page 20

    Yamaha corporation pro audio & digital musical instrument division p.O. Box 3, hamamatsu, 430-8651, japan v639260 r2 1 cp 20 np printed in taiwan.