Yamaha MW12C Owner's Manual - page 11
Mixer Basics
Quick Guide
MW12CX/MW12C Owner’s Manual
11
4
Select [ASIO DirectX Full Duplex Driver]
(Windows), [USB Audio CODEC] (Mac) in
the [Devices] field on the left side of the
Device Setup window, and click [Control
Panel] on the right side of the window.
Windows:
The ASIO Direct Sound Full Duplex Setup dialog box
will be displayed. Check only the input port and output
port [USB Audio CODEC] checkbox, and then click
[OK] to close the dialog window.
Mac:
The [CoreAudio Device Settings] dialog window
appears. Check only the [USB Audio CODEC] check-
box in both “Input” and “Output” of the [Input/Output
Configuration] field. Click [Close] to close the dialog
window.
5
Make sure that “USB Audio CODEC 1/2”
(Windows), “Front Left/Front Right” (Mac)
are shown in the [Port System Name] field,
and check the [Visible] column in the
Device Setup window. Click [OK] to close
the window.
If the [Port System Name] field does not
change, close and restart the Cubase AI, then
open the Device Setup window.
6
Select [VST Connections] from the
[Devices] menu.
Windows:
If “Not Connected” is selected in the [Audio Device]
field, click on the “Not Connected” indication, and then
switch to [ASIO DirectX Full Duplex Driver].
Also set the [Outputs] in the same way, and then close
the window.
Mac:
If “Not Connected” is selected in the [Audio Device]
field, click on the “Not Connected” indication, and then
switch to [USB Audio CODEC].
Also set the [Outputs] in the same way, and then close
the window.
7
Select [Add Track]
→ [Audio] from the
[Project] menu.
The Add Audio Track dialog window appears.
8
Set the “Count” and “Configuration”
parameters, and then click [Add Track].
The added tracks will appear.
You will normally use a stereo track when
recording synthesizers, and a monaural track
when recording vocals or guitars.
NOTE
NOTE