Yamaha PCY100 Owner's Manual

Other manuals for PCY100: Owner's Manual
Manual is about: DTX ELECTRONIC DRUM PAD

Summary of PCY100

  • Page 1

    Pcy100 pcy135 pcy155 electronic drum pad owner’s manual bedienungsanleitung mode d’emploi english 取扱説明書 d eutsc h fr ançais ja zh fr de en.

  • Page 2

    2 the name plate of this product may be found on the bottom of the unit. The serial number of this product may be found on or near the name plate. You should note this serial number in the space provided below and retain this manual as a permanent record of your purchase to aid identification in the...

  • Page 3

    3 (weee_eu) (weee_eu) (weee_eu) information for users on collection and disposal of old equipment this symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery ...

  • Page 4

    4 english the purpose of the precautions detailed below is to ensure that this product is used safely without fear either of accidental injury to you or other people or of damage to property. As a means, furthermore, of indicating the severity and immediacy of any risk of injury or damage associated...

  • Page 5

    5 if you have purchased a pad set, please refer to the assembly instructions booklet that came with it. Pcy100: q pcy100 pad unit x 1, r stopper x 1, t felt pad x 1, u stereo phone cable x 1, i owner’s manual (this booklet) x 1 pcy135: w pcy135 pad unit x 1, r stopper x 1, y felt pad x 1, u stereo p...

  • Page 6

    6 as shown in the diagram, set up your pad unit on an electronic drum rack or a standard cymbal stand (such as a yamaha cs series product). 1 using a tuning key (optional), loosen the stopper’s key bolt. (see figure 1.) 2 remove the wing nut, the two felt pads, and the bolt cover from the cymbal hol...

  • Page 7

    7 6 place one of the felt pads removed in step 2 on the cymbal holder. (see figure 5.) 7 mount the pad unit on the cymbal stand. Lower the pad unit into place with the cymbal holder’s shaft passing through the central hole of the cup section. When mounted, the stopper’s pin should rest inside the pa...

  • Page 8

    8 using the stereo audio cable provided, connect the pad unit’s output to a suitable input jack on a dtx series drum trigger module. At this time, ensure that the l-shaped end of the cable is plugged into the pad unit’s output connector. Using a small screwdriver or a similar tool, you can turn the ...

  • Page 9

    9 if you encounter any of the following difficulties when playing your pcy series pad unit, please take the steps indicated to resolve them before ordering repairs. No sound, volume is low is the pad connected to the correct input number of the dtx series drum trigger module using the supplied stere...

  • Page 10

    Pcy100_135_155_om_end.Fm page 2 tuesday, november 9, 2010 4:08 pm.

  • Page 11

    Pcy100_135_155_om_end.Fm page 3 tuesday, november 9, 2010 4:08 pm.

  • Page 12

    For details of products, please contact your nearest yamaha representative or the authorized distributor listed below. Die einzelheiten zu produkten sind bei ihrer unten aufgeführten niederlassung und bei yamaha vertragshändlern in den jeweiligen bestimmungsländern erhältlich. Pour plus de détails s...

  • Page 13

    Wu21460 011po***.*-01a0 © 2011 yamaha corporation u.R.G., digital musical instruments division http://www.Yamaha.Co.Jp/manual/ yamaha manual library http://dtxdrums.Yamaha.Com yamaha electronic drums web site.