Yamaha Raptor YFM7RB Owner's Manual - page 107
of
158
8-25
8
2. Remove the tailpipe by pulling it out of the
muffler.
3. Tap the tailpipe lightly, and then use a wire
brush to remove any carbon deposits from the
spark arrester portion of the tailpipe and inside
of the tailpipe housing.
4. Insert the tailpipe into the muffler and align the
bolt holes.
5. Install the bolt and tighten it to the specified
torque.
6. Remove the purging bolt and the gasket.
1. Tailpipe
2. Tailpipe bolt
2
1
1. Tailpipe
2. Spark arrester
Tightening torque:
Tailpipe bolt:
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
1
2
U1AS12E0.book Page 25 Wednesday, February 2, 2011 11:55 AM