1. DL manuals
  2. Yamaha
  3. Guitar
  4. Silent Guitar SLG-100S
  5. Owner's Manual

Yamaha Silent Guitar SLG-100S Owner's Manual

Other manuals for Silent Guitar SLG-100S: Brochure
Manual is about: Yamaha PAC012DLX: Product Brochure

Summary of Silent Guitar SLG-100S

  • Page 1

    1 thank you for purchasing the yamaha silent guitar. In order to obtain the maxi- mum performance and enjoyment from your silent guitar, we urge you to read this owner’s manual thoroughly before using the instrument. Please keep this owner’s manual in a safe place for later reference. Contents preca...

  • Page 2

    2 special message section 92-bp this product utilizes batteries or an external power supply (adaptor). Do not connect this product to any power supply or adaptor other than one described in the manual, on the name plate, or specifically recommended by yamaha. This product should be used only with th...

  • Page 3

    3 your silent guitar will give you years of reliable service if you follow the simple rules given below: ■ location do not expose it to the following conditions to avoid deformation, discoloration, or more serious dam- age. • direct sunlight (e.G. Near a window). • high temperatures (e.G. Near a hea...

  • Page 4: Main Body/accessories

    4 main body/accessories after opening the packaging, please check that all the parts listed below are in- cluded. • main body • left frame • ac adaptor : pa-d09 • stereo earphones • soft case 02_slg100s_en.Pm65 06.8.22, 11:05 am 4.

  • Page 5: Nomenclature

    5 nomenclature ● front ● rear fingerboard neck saddle tuning peg nut body pickup (underneath the saddle) controls → see page 6. Frame attachment screw 1 (doubles as the strap pin) left frame (removable) right frame (fixed) bridge horn (leg support) frame attachment screw 2 (doubles as the strap pin)...

  • Page 6: ● Controls

    6 ● controls volume control battery compartment reverb switch power lamp aux in jack aux in level control cord hook line out jack dc-in jack (power adaptor connector) dc-in 9~12v + – bass control treble control phones on/off switch phones jack off 1 2 off on phones reverb v olume b ass treble open l...

  • Page 7: Attaching The Frame

    7 open line out aux in aux vol min max this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesi...

  • Page 8: Tuning

    8 tuning use a tuning meter, pitch pipe, tuning fork, piano, etc., and tune the open strings to the pitches shown below. • if the string’s pitch is high, loosen the string until the string’s pitch is slightly lower than the tuning pitch, then tune while raising the string’s pitch. 1f 2f 3f 4f 5f 1. ...

  • Page 9: Power Supply

    9 power supply the silent guitar operates either on battery power or with an ac adaptor however, it will consume more power when the reverb function is in use. For that reason, we recommend that it be powered with the supplied ac power adaptor for normal use. Always turn the phones on/off switch off...

  • Page 10: Using The Controls

    10 using the controls ■ using the line out jack (using with a guitar amplifier or powered speaker, etc.) 1. Use a standard phone plug cable to connect the silent guitar’s line out jack to the input jack on the guitar amplifier or powered speaker, etc. When the cable’s plug is inserted into the line ...

  • Page 11: Using The Soft Case

    11 when putting the silent guitar into the supplied soft case, remove the left frame from the silent guitar, and then place in the individual parts in the case as shown in the illustration below. • put the left frame into the case’s larger pocket. • put the power adaptor into the smaller pocket in t...

  • Page 12: Connecting External Devices

    12 open line out aux in aux vol min max 3 line out aux in aux vol min max line out aux in phones dc-in this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any int...

  • Page 13

    13 ■ aux in jack • the aux in jack can be used to connect an external stereo signal source to the silent guitar. Connecting the audio output of a cd player, cassette player, etc. To the instrument allows you to play along with the external audio source. • the aux in jack’s signal level can be contro...

  • Page 14: Specifications

    14 specifications neck mahogany body maple fingerboard rosewood bridge rosewood frame unit maple strings steel strings for acoustic guitar sensors lr-baggs connectors/controls • aux in • aux in level control • line out jack (monaural) • phones jack (stereo) • volume • bass control • treble control •...

  • Page 15

    Wh98210 r0 printed in indonesia 07_slg100s_last.Pm65 06.7.26, 3:58 pm 4.