1 simplek – stick operation manual version for yamaha.
2 attention! Before first use, please read the operation and safety instructions carefully! Simplek-stick – assembly set 1.0 general remarks and savety instructions 2.0 assembly and installation 2.1 assembly of parts 2.2 installation 3.0 handling 3.1 calibration 3.2 tuning-mode 3.2.1 reset of the ma...
3 1.0 general remarks and safety instructions the offered “simplek-stick“-assembly set (here called as “simplek-stick“) will be delivered in individual parts and cannot be used in delivery conditions. The assembly set is only allowed to be used by experts allowing for applicable regulations and stan...
4 2.0 assembling and installation the simplek-stick consists of 4 components only: • circuit board (fig. 1) • connection cable (fig. 2) • usb plug (fig. 3) • usb enclosure (fig. 4) the assembly is simply designed. Figure 01 - circuit board figure 02 - connection cable figure 03 – usb plug figure 04 ...
5 2.1 assembly the board is already equipped with the smd components when delivered. Only the usb plug has to be inserted and soldered on the same side. Make sure the plug is fully seated on the board (fig. 5) before you start soldering. In order to ensure complete protection against water, it is re...
6 figure 05 – circuit board witrh usb-plug figure 06 – circuit board inserted figure 07 – close enclosure figure 08 – closed enclosure.
7 2.2 installation before you start with the installation, remove the battery of your e-bikes! The connection cable is upstreamed in front of the original sensor. For this purpose the motor cover has to be removed. Depending on the engine version you need additional tools..
8 installation based on an engine version yamaha pw: required tools: • 3 mm allen key • 6 mm allen key • small screwdriver unscrew the three 3 mm allen screws (fig. 9). It is possible that these are provided with a screw-locking device. In this case, heat the screws first. Remove the two 6 mm allen ...
9 3.0 operation the simplek-stick includes 2 operation modes: [1] tuning-mode [2] calibration-mode a change from tuning mode to calibration mode is made by plugging the simplek into any active usb port for at least 5 seconds. The next time you plug in the simplek-stick on the e-bike, the calibration...
10 3.1 calibration the calibration has to be carried out once and has to be shifted during standstill and with an inserted battery pack. On first start, the calibration will be automatically called up. It consists of two sections. At first it will be grossly calibrated, then more precise. In order t...
