- DL manuals
- Yamaha
- Speaker System
- SW-P201
- Owner's Manual
Yamaha SW-P201 Owner's Manual
Summary of SW-P201
Page 1
I ns-p320 (including sw-p201 subwoofer system) home cinema 5.1ch speaker package owner’s manual u b.
Page 2: Safety Instructions
Ii • explanation of graphical symbols the lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to pe...
Page 3: III
Iii we want you listening for a lifetime yamaha and the electronic industries association’s consumer electronics group want you to get the most out of your equipment by playing it at a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion – and, most ...
Page 4: Unpacking
Iv unpacking after unpacking, check that the following items are contained. ● main speakers ● rear speakers ● center speaker ns-m104 > ns-c104 > sw-p201 > ns-e104 > x 4 [4m] [15m] x 3 x 2 ● subwoofer ● audio connection cable ● speaker cables ● fastener ● pads.
Page 5
E- 1 ● to assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. ● install the speakers in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transform...
Page 6: Contents
E- 2 contents safety instructions .............................. Ii unpacking .................................................. Iv caution ......................................................... 1 components of the package .............. 2 setting up the speakers ...................... 3 placing ...
Page 7: 䡵 Placing The Subwoofer
E- 3 䡵 placing the subwoofer it is recommended to place the subwoofer on the outside of either the right or the left main speaker. (see fig. Å .) the placement shown in fig. ı is also possible, however, if the subwoofer system is placed directly facing the wall, the bass effect may die because the s...
Page 8
E- 4 place the speaker on tv whose top is flat or on the floor under the tv or inside the tv rack so that it is stabilized. When placing the speaker on top of the tv, to prevent the speaker from falling down, put the provided fasteners at four points on the bottom of the speaker and the top of the t...
Page 9
E- 5 mount the rear speakers on a shelf, rack or directly on the floor, or hang them on the wall. To mount the rear speakers on a wall by using the holes on the speakers’ back panels note it is recommended that you connect the speaker cables to the speaker’s terminals before attaching the bracket to...
Page 10: Connections
E- 6 impeda set b main a or b: 4 m a + b: 8 m center : 6 m rear : 6 m speakers main + – r l a – + b center rear (surround) r l + – eo sub woofer output ma cen re /mono volume input1 from amplifier output to speakers input2 auto standby standby-red on-green off low high off power on 0 i0 input2 /mono...
Page 11
E- 7 ● connect the main, center and rear speakers to the speaker output terminals of your amplifier with the provided speaker cables. * connect each speaker making sure not to reverse the polarity (+, –). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass. ...
Page 12: Of The Speakers
E- 8 main/center/rear speakers one side of the provided speaker cable has a white broken line and the other side has no line. Connect the (+) terminals on both the speaker and the amplifier using the side with a white broken line. Connect the (–) terminals on both components using the side with no l...
Page 13: Amplifier
E- 9 a b /mono volume input1 from amplifier output to speakers input2 auto standby standby-red on-green off low high off power on 0 i0 input1 from amplifier output to speakers /mono volume input1 from amplifier output to speakers input2 auto standby standby-red on-green off low high off power on 0 i...
Page 14
E- 10 input1 from amplifier output to speakers input2 /mono auto standby standby-red on-green off low high off power on 1 volume 0 i0 off power on 5 6 4 input1 from amplifier output to speakers input2 /mono auto standby standby-red on-green off low high volume 0 i0 2 3 7 voltage selector 220v-240v 1...
Page 15: 1, 5
E- 11 1 set the volume control to minimum (0). 2 turn on the power of all the other components. 3 set the power switch to the on position. * the power indicator lights up in green. 4 play a source and adjust the amplifier’s volume control to the desired listening level. 䡵 adjusting the subwoofer bef...
Page 16: (For Sw-P201)
E- 12 advanced yamaha active servo technology (for sw-p201) the theory of yamaha active servo technology has been based upon two major factors, the helmholtz resonator and negative-impedance drive. Active servo processing speakers reproduce the bass frequencies through an “air woofer”, which is a po...
Page 17: Troubleshooting
E- 13 problem power is not supplied even though the power switch is set to the on position. No sound. Sound level is too low. The subwoofer does not turn on automatically. The subwoofer does not turn into the standby mode automatically. The subwoofer turns into the standby mode unexpectedly. The sub...
Page 18: Specifications
E- 14 specifications 䡵 ns-m104 type .............................. 2-way bass-reflex speaker system magnetic shielding type driver ........................................ 12 cm (4-3/4”) cone woofer 2.5 cm (1”) balanced dome tweeter impedance ............................................................
Page 19
Yamaha electronics corporation, usa 6660 orangethorpe ave., buena park, calif. 90620, u.S.A. Yamaha canada music ltd. 135 milner ave., scarborough, ontario m1s 3r1, canada yamaha electronik europa g.M.B.H. Siemensstr, 22-34, 25462 rellingen, bei hamburg, f.R. Of germany yamaha electronique france s....