Pedal timpani timbale À pÉdale timbal de pedal 踏板定音鼓 tp-62 20 /23 /26 /29 /32 tp-42 23 /26 /29 /32 tp-50 20(g/h) /23 (g/h) /26 (g/h) /29 (g/h) /32 (g/h) tp-70 20(h) /23(h) /26(h) /29(h) /32(h) tp-72 20 / 23 / 26 / 29 / 32 owner’s manual mode d’emploi manual de instrucciones 用户手册 english français esp...
2 thank you for selecting a yamaha musical instrument. We are confident that the instrument will bring you years of musical enjoyment and satisfaction. Please read through this booklet care- fully. It contains important information about your instrument's care. Your new yamaha instrument, like all y...
3 head kettle edge kettle caster strut head protector base third wheel (removable) tuning bolt pointer lock nut pointer adjustment knob hoop (counter hoop) tuning indicator (tuning gauge) points of lubrication pac adjustment bolt spring tension adjustment bolt tuning pedal caution * the illustration...
4 before using the pedal timpani fig. B fig. A adjuster wire tube fig. C fig. D wrong collar collar counter hoop counter hoop kettle edge kettle edge caution correct your yamaha pedal timpani is equipped with a plastic head carefully mounted and tuned (adjusted to a note) at the factory, and thus ca...
5 before using the pedal timpani timpani key 26”, 29”, 32” 20”, 23” note striking point pedal 5 using the supplied timpani key, tighten the tun- ing bolts by 1/4 of a turn (90 °) in the order shown below. It is very important to always turn all tuning bolts by the same amount. 9 tighten each tuning ...
6 adjusting the sound of your timpani striking point pedal when using the pedal timpani for the first time after unpacking, make sure to set it up according to the instructions of section “before using the pedal timpani” on pages 4 and 5. When loosening the tuning bolts, always loosen them by double...
7 adjusting the sound of your timpani timpani key spring spring tension adjustment bolt 6 repeat steps 3 through 5 until the pitch at each bolt is exactly the same. 7 check the sound by striking the head as de- scribed in step 2 . ● sound lower than tuning note → tune the instrument by tightening al...
8 indicator rail note pointer pointer note indicator rail adjuster adjustment nut ● adjusting the pointer position first loosen the pointer lock nut and then turn the adjuster as follows: ● pointer is located beyond the lower rail end when heel of pedal is lowered fully (lowest note) → turn the adju...
9 pac adjustment bolt the pac (pedal adjustment clutch) is an original yamaha mechanism that enables you to adjust the pedal’s rotational torque (the force required to move the pedal) by altering the amount of friction within the pedal balance spring mechanism. Using the pac, you can adjust the rota...
10 moving and setup your timpani mounting plate pedal base locking shaft hold the instrument by its frame and push in the direction opposite the pedal. * the illustration shows a pedal timpani of the tp-62xx series. After setting up the timpani, lock the other two casters to stabilize the instrument...
11 softball etc. Hoop cellophane tape pedal caution replacing the head 1 to prevent the pedal from being pulled down by the spring force, the heel of the pedal must be kept down (this can easily be accomplished by placing a piece of wood or a softball between the base and the pedal) while the tuning...
