Home theater sound system tss-1 owner’s manual mode d’emploi bedienungsanleitung bruksanvisning manuale di istruzioni manual de instrucciones gebruiksaanwijzing active servo technology g b digital 4ch 2ch dts digital center surround subwoofer prologic input mode mute test master volume active servo ...
Speaker outputs digital inputs optical coaxial analog inputs front surround speaker mode 5ch 4ch 2ch l r front l r 1 2 surround center s. Woofer dc in 15v digital 4ch 2ch dts digital center surround subwoofer prologic input mode mute test master volume active servo technology home theater sound syst...
English e- 1 please read the following operating precautions before use. Yamaha will not be held responsible for any damage and/or injury caused by not following the cautions below. ● when you disconnect the ac adaptor from the ac receptacle, hold the plug itself and not the cord. ● if you plan not ...
E- 2 contents cautions .......................................................... 1 unpacking ...................................................... 2 features ......................................................... 2 setting up the speakers ................................ 4 connections ............
English e- 3 welcome to the exciting world of digital home entertainment. The tss-1 is a compact, but complete and advanced home theater sound system that takes you to the exciting world of digital surround sound entertainment. Though some of the advanced features of this system may not be familiar ...
E- 4 system configuration this system includes an amplifier unit, five satellite speakers and a subwoofer. The three satellite speakers with a 3 m cord are used for front speakers and a center speaker. The two satellite speakers with a 7 m cord are used for surround speakers. The roll of respective ...
English e- 5 m adjusting the front angle of the satellite speakers the front angle of the satellite speakers can be adjusted as shown below. 1 loosen the screw on the bottom of the speaker stand. * put the supplied nonskid pads at the four corners on the bottom of the stand to obtain more stability....
E- 6 (see figure 1 on inside of the front cover.) caution: plug in the amplifier unit and other equipment after all connections are completed. A : connect three satellite speakers with a 3 m cord to the front l, r and center terminals. Connect two satellite speakers with a 7 m cord to the surround l...
English e- 7 7 subwoofer level control this control is used for adjusting the level of sound outputted from the subwoofer. Turn this control clockwise to increase the level, and counterclockwise to decrease the level. 8 master volume control this control is used for adjusting the whole volume level ...
E- 8 this section explains how to turn on this system and select input sources. Before turning on this system, turn on the external audio unit to be used. 1 turn the master volume control fully counterclockwise to decrease the volume to minimum. 2 turn on this system. 3 select the appropriate input ...
English e- 9 cause the ac adaptor is not properly plugged into the ac receptacle. The power of this system is set to off. Connections are faulty or incomplete. Appropriate input mode is not selected. The volume setting is low. The mute function is active. (the indicator on the left side of the mute ...
E- 10 control unit minimum rms output power per channel ........................ 20w + 20w (20 hz–20 khz, 6 Ω , 0.4% thd) maximum power .......... 26w + 26w (1 khz, 6 Ω , 10% thd) input sensitivity/input impedance pc in, aux1 in, aux2 in (analog) ........ 150 mv/35 k Ω maximum input signal pc, aux1,...
