Yamaha YFM35FGW Owner's Manual - Handlebar Switches
4-3
4
EBU17952
On-Command four-wheel-drive indicator light
“
”
This indicator light comes on when the On-Com-
mand four-wheel-drive switch is set to the “4WD”
position.
NOTE:
Due to the synchronizing mechanism in the differ-
ential gear case, the light may not come on until
the ATV starts moving.
EBU18060
Handlebar switches
EBU18080
Engine stop switch “
/
”
Set this switch to “
” before starting the engine.
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to “
”.
EBU18100
Start switch “
”
Push this switch to crank the engine with the start-
er.
CAUTION:
ECB00050
See the starting instructions on page 6-1 prior
to starting the engine.
EBU18151
Light switch “
/
/OFF”
Set this switch to “
” to turn on the low beams
and the taillight. Set the switch to “
” to turn on
the high beams and the taillight. Set the switch to
“OFF” to turn off all the lights.
1. Light switch “
/
/OFF”
2. Engine stop switch “
/
”
3. Start switch “
”
U5UH14E0.book Page 3 Thursday, April 13, 2006 6:30 PM