Z-Tec RED User Manual - page 4
Assembling the Walker
2.
1.
NOTE: The brakes are factory set & may not require initial adjustment. For technical assistance on the brakes, contact your local Z-
Tec dealer.
1.
Remove all packaging from the walker.
2.
Extend Frame ready for normal use.
Release Star Loc Knob then pull frame out
until Locking Button is engaged, then
re-tighten Star Knob.
To Close, release Star Knob and press
Release / Locking Button, then push
frame in, then re-tighten Star Knob.
Frame Extends for Normal Use
Unfold Walker & Press Locking Bar
3.
Insert the handles as shown by A into the down tube B until the required height of the handles is reached, then locate the
black star knob into the fixed threaded section, see C & securely fasten turning the knob clock wise. Be careful to line up correctly
before tightening to avoid damage to the threads.
A
B.
Release / Locking Button
CAUTION: DO NOT USE UNTIL
FRAME HAS BEEN EXTENDED &
LOCKED INTO PLACE
Star Loc Knob
CAUTION: ENSURE BOTH HANDLES
ARE SAME HEIGHT BEFORE USE.
3.
C.