Z-Wave Control4 Setup Manual - page 8
8
3Identify (add) the Z-Wave device according to the manufacturer’s
instructions, usually by pressing a Z-Wave button on the device. See the
documentation for the Z-Wave device for more information.
Note: You have 60 seconds to identify (add) the Z-Wave device to the network
and a timer will show the time remaining. If you run out of time, close the
window and try to identify the Z-Wave device again.
4After adding the Z-Wave device to the Z-Wave network, the driver will do
some additional configuration.
Important: Do not skip this step by closing the window or clicking next!
5If the device is added, configured, and identified successfully, the address
will show in the address field and the timer instructions will change to say
“Identification Successful”.
Note: If the Z-Wave device will not identify (add), you should try to remove the
device and then try to identify the device again. See “
Removing Z-Wave
devices
”.